GeoVision GV-GDRF4800 handleiding
Handleiding
Je bekijkt pagina 33 van 77
22
3.2.6 Smart Supplement Light Configuration
1. Set the illumination mode to “Smart Supplement Light” in the Display Setting interface.
2. Go to Config→Image→Smart Supplement Light.
3. Set alarm areas. Select the alarm area number. Four alarm areas can be added.
Click the “Draw Area” button and then click around the area where you want to set as the
alarm area in the image (the alarm area should be a closed area). Click the “Stop Draw”
button to stop drawing. Click the “Clear” button to delete the alarm area.
4. Set the detection target and sensitivity. “Human” is selected by default. You can also
select “Motor Vehicle” or “Motorcycle/Bicycle” as needed.
Sensitivity: The higher the value is, the easier the white light will be triggered by targets.
5. Set the duration of the white light. In low ambient light, the system will automatically turn
on the visible infrared light. Once there are people/vehicles appearing in the set alarm
area, it will automatically switch to full-brightness visible white light. When people/vehicles
leaving the alarm area exceed the set duration and no other persons/vehicles are
detected during the period, it will resume to infrared light.
6. Click “Save” to save the settings.
Note: If the people/vehicles staying and not moving in the detection area exceed the set
duration, it will resume to infrared light too.
Bekijk gratis de handleiding van GeoVision GV-GDRF4800, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | GeoVision |
| Model | GV-GDRF4800 |
| Categorie | Bewakingscamera |
| Taal | Nederlands |
| Grootte | 13260 MB |
