Gentrax GTX3500 handleiding
Handleiding
Je bekijkt pagina 9 van 22
8
4. OPERATION
NOTE: ───────────────────────
The generator has been shipped without engine oil. Fill with oil or it will not
start.
Do not tilt the generator when adding engine oil. This could result in
overfilling and damage to the engine
───────────────────────────
1）STARTING THE ENGINE
NOTE: ─────────────────────
Before starting the engine, do not connect the electric apparatus.
─────────────────────────
A Recoil start
1. Open the fuel tank air vent to the “OPEN” position.
2. Turn the fuel cock lever to the “ON” position.
3. Turn the engine switch to the “ON” or “RUN” position.
4. Turn the choke lever to the “│ │”position. Not necessary if the engine
is electric type.
5. Pull the starter handle slowly until resistance is felt. This is the
“Compression” point. Return the handle to its original position and pull
swiftly. Do not fully pull out the rope. After starting, allow the starter handle
to return to its original position while still holding the handle. Grasp the
carrying handle firmly to prevent the generator from falling over when
pulling the recoil starter.
6. Warm up the engine.
7. Turn the choke lever back to the operating position. Not necessary if the
engine is electric type.
8. Warm up the engine without a load for a few minutes.
B Electric start
1. Open the fuel tank air vent to the “OPEN” position.
2. Turn the fuel cock lever to the “ON” position.
3. Turn the engine switch to the “START” position.
4. Turn the engine switch to the “RUN” position
OPEN
ON
ON
STOP
ENGINE
SWITCH
STOP
RUN
START
ENGINE
SWITCH
Bekijk gratis de handleiding van Gentrax GTX3500, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Gentrax |
| Model | GTX3500 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 3224 MB |
