Gentrax GT2000 handleiding
Handleiding
Je bekijkt pagina 8 van 16
OPERATIONS
WARNING! Before connecting any electrical
load to the generator ensure that the load
does not exceed the maximum as stated in
the manual. Ensure that the appliance being
connected is in good working order and that
the mains supply lead is long enough to reach
the generator without any strain.
WARNING! DC power and AC power can be
used at the same time but DO NOT exceed the
maximum power output, as shown on the manual.
Under normal working conditions the (Green)
output indicator light will be illuminated.
If the generator is overloaded or if there is a
malfunction or a short circuit in a connected
appliance, the (Green) output indicator will
extinguish and the (Red) overload indicator
light illuminates and the power to the connect-
ed appliance will be disconnected.
When an electric motor is started, both the (Red)
overload indicator and the (Green) output indicator
will illuminate simultaneously. This is normal, the
(Red) over- load indicator extinguishes after about
four (4) seconds. If the (Red) overload indicator
remains illuminated, consult your generator dealer.
For equipment with an inductive load
(more power will be required at initial
start). Under these conditions it is
normal for both the (Red) overload
indicator and the (Green) output
indicator will illuminate simultaneously
for a short period about four (4)
seconds. After the appliance starts,
the (Red) over-load indicator
extinguishes and the (Green) output
indicator will remain illuminated.
BREAK IN PERIOD
Breaking-in the Engine will help to ensure
proper equipment and Engine operation.
The break-in period will last about 25
hours of use.
DO NOT exceed 75% of the Generator’s rated
capacity during this period.
Change the Engine oil after this period. Under
normal operating conditions subsequent
maintenance follows the schedule explained
in the MAINTENANCE section.
DC BATTERY CHARGING FUNCTION
This function is applicable to 12v battery
charging only.
Disconnect the leads from the battery, Loosen
the vents on the battery. Ensure the battery
fluid level is correct.
Using a hydrometer (not supplied) measure the
specific gravity of the battery fluid and calculate
the charging time accordance with table shown.
Attach the 12v charging leads to the battery
observing the correct polarity
(Red = + Positive) (Black = - Negative)
Plug the 12v charger lead into the socket on
the generator. The specific gravity for the fully
charged battery shall be within 1.26 to 1.28.
Check the gravity every hour.
a.
b.
Battery capacity
1. 30AH 20HR
2. 35AH 20HR
3. 47AH 20HR
Aim for specific gravity and charging time
7INVERTER GENERATOR: User Manual
C
M
Y
CM
MY
CY
CMY
K
Page 7.ai 1 9/2/2014 7:31:31 AMPage 7.ai 1 9/2/2014 7:31:31 AM
Bekijk gratis de handleiding van Gentrax GT2000, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Gentrax |
| Model | GT2000 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 3270 MB |
