Gefen GF-HDK18G-VIP-RX handleiding
Handleiding
Je bekijkt pagina 40 van 134
40
3. Locate the Serial over IP group and change the RS-232 settings to match the
settings of the RS-232 device that is being used. In this case, we need to use the
settings from the table above.
• Extension is the default setting for serial pass-through.
• Selecting the Bridge option allows Telnet to be output to the serial interface.
Telnet listening port 6752 is used. This applies to either the Sender or Receiver
unit.
4. Make sure that the Enable Serial over IP box is checked.
Important: If Enable Serial over IP is not checked, then RS-232 pass-through will be
disabled.
5. Click the Apply button in the lower-right corner of the Serial over IP group.
The following message will be displayed, at the top of the page, indicating that the
new Serial over IP options have been applied.
6. Click the Reboot button at the bottom of the page. If the Reboot button is not
clicked, the following message will be displayed, indicating that the unit must be
rebooted.
7. Repeat steps 1-6 for the Receiver unit.
Using RS-232
Bekijk gratis de handleiding van Gefen GF-HDK18G-VIP-RX, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Gefen |
| Model | GF-HDK18G-VIP-RX |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 12456 MB |
