Garrett Paragon handleiding
Handleiding
Je bekijkt pagina 37 van 44
1557900 REV B1 Paragon User Manual 37
9.2 Error Code Table Diagnostics
Critical Failures and Non-Critical Failures
Failures are classied as either “critical” or “non-
critical” (see table in Figure 9-1). A critical failure
prevents the Paragon from operating and must be
corrected immediately. When a critical failure oc-
curs, the audio alarm sounds, the overhead display
begins ashing and the message, SYSTEM FAIL-
URE, appears on the OLED Display.
A non-critical failure does not prevent the Para-
gon from operating; however, it should be corrected
as soon as possible.
9.3 Repair
e Paragon’s modular design facilitates
assembly and maintenance.
If problems are site-related, see Section 3.1 or
contact the factory for assistance. Often adjusting
or relocating the equipment, or removing nearby
objects resolves problems.
If the equipment does not perform properly,
contact the factory for assistance.
• Controller Board
e controller board, located in the
detection unit, contains the primary circuit board
required for operation. e cables that connect
the controller board to the side panels are plugged
into connectors at the top of each panel. e
controller module cover should not be removed
except to:
• Revert access codes to factory setting (see
Section 5.7.);
• Perform a repair;
• Connect sync wires.
• Power Module
e power module supplies the power required
for operation. Ensure that the power jumper is
plugged into the connector on the lower left side
of the module and to the panel connected to the
power outlet.
• Power Cord
A detachable power cord is supplied to meet
North American or European standards. If
an alternate cord is used ensure that the
cord is adequately rated.
• Battery
e lithium battery modules contain internal
battery monitoring circuitry. Accuracy of the
charge indication inproves with repeated
charge and discharge cycles. To remove battery,
hold the back of the battery on the right
side with one hand and with the other hand,
press the white spring-loaded button on the battery
while sliding it to the right, away from battery car-
rier. Because the battery is heavy, use both hands
to hold it while removing it from the carrier and
taking it out of the detection head. To replace a
battery, place it into the carrier with both hands
and ensure it is aligned with the carrier and is free
from cables or other objects that may prevent it
from seating properly. e battery should slide
smoothly and freely to the left until the white
spring-loaded button snaps into place.
Maintenance / Troubleshooting
Bekijk gratis de handleiding van Garrett Paragon, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Garrett |
| Model | Paragon |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 6746 MB |