Gardena EasyWeed 1800/18V P4A handleiding
Handleiding
Je bekijkt pagina 14 van 166

14
Problem Possible cause Remedy
The weed brush does
not start or stops.
Error LED
Wp
is
illuminated red
[Fig. O4].
Battery temperature is
outside the permissible
range.
Wait until the battery
temperature is between
0 °C and + 45 °C again.
There are drops of water
or moisture between the
battery contacts.
Use a dry cloth to
remove the water
drops or moisture.
An obstruction is blocking
the motor.
Remove the
obstruction.
The weed brush does
not start or stops.
Error LED
Wp
ashes
red [Fig. O4].
The product is damaged. Contact GARDENA
Service.
The weed brush does
not start or stops.
Error LED
Wp
is not
illuminated [Fig. O4].
The battery is not fully
inserted into the battery
holder.
Insert the battery fully
into the battery holder
until it you hear it
engage.
The battery is damaged. Replace the battery.
The product is damaged. Contact GARDENA
Service.
The charge cycle is not
possible.
Battery charge
indicator
Lc
glows
continuously green.
The battery is not
(correctly) connected.
Connect the battery
to the battery charger
correctly.
The battery contacts
are dirty.
Clean the battery
contacts (e.g. by
connecting and
disconnecting the
battery several times).
Replace the battery if
necessary.
The battery temperature is
outside of the permissible
range.
Wait until the battery
temperature is between
0 °C and + 45 °C again.
The battery is damaged. Replace the battery.
The charge cycle is not
possible.
Battery charge
indicator
Lc
does
not illuminate.
The mains plug of the
battery charger is not
plugged in correctly.
Insert the mains
plug fully into the
power outlet.
The power outlet, power
cord or battery charger is
damaged.
Check the mains
voltage. If necessary,
have the battery
charger checked by an
authorised dealer or by
GARDENA Service.
Note:
Repairs may only be carried out by GARDENA service centres or by
specialist dealers approved by GARDENA.
Please contact your GARDENA service centre in the event of other
faults (see reverse).
7. TECHNICAL DATA
Cordless weed brush Unit Value (Art. 14820)
Brush speed (min/max) RPM 700–1800
Diameter of the steel
wire brush
mm 110
Weight
(without battery)
kg 2.2
Sound pressure level
L
PA
1)
Uncertainty k
PA
dB
67
3
Sound power noise
level L
WA
2)
measured / guaranteed
Uncertainty k
WA
dB(A)
87 / 90
3
Hand arm vibration
a
vhw
1)
Uncertainty k
vhw
m/s
2
≤ 2.5
1.5
Measurement methods according to:
1)
EN 62841-4-4
2)
RL 2000/14/EC / S.I. 2001 No.1701
4.2. Replacing the brush
If the housing of the cordless weed brush touches the ground while
cleaning joints due to wear, the brush must be replaced.
Replace the brush (see “2.2. REPLACING THE BRUSH [FIG. A1]”).
4.3. Cleaning the battery and the battery charger
DANGER!
Risk of injury
Inserting the battery may cause you to trap your ngers.
Mind your ngers.
The surface and contacts of the battery and of the battery charger must
be clean and dry before connecting the battery to the battery charger.
Do not use running water.
4.3.1 Cleaning the battery
Do not use any chemical substances to clean the battery.
Use a soft, clean, dry brush to clean the ventilation slots and the
contacts of the battery from time to time.
4.3.2 Cleaning the battery charger
Use a soft, dry cloth to clean the contacts and the plastic parts.
5. STORAGE
5.1. Decommissioning
The product must be stored away from children.
1. After use, allow the battery to cool down before charging or storing it.
2. Remove the battery.
3. Charge the battery.
4. Clean the weed brush, the battery and the battery charger
(see 4. MAINTENANCE).
5. Store the weed brush, battery and battery charger in a dry, enclosed
and frost-proof location.
6. Do not store the weed brush in an upright position on the brush.
This prevents deformation of the brush.
6. TROUBLESHOOTING
DANGER!
Risk of injury
If the product starts accidentally, people can be injured by the
weed brush.
Remove the battery before servicing the product.
Do not touch moving parts.
Problem Possible cause Remedy
The weed brush is
blocked.
An obstruction is blocking
the weed brush.
Remove the
obstruction.
The protective
cover
5
is damaged.
The protective cover
5
has cracks or holes.
Replace the protective
cover
5
.
Contact GARDENA
Service for this.
The weed brush does
not clean properly or
vibrates.
The weed brush is worn. Replace the weed
brush.
The weed brush does
not stop.
Start lever is jammed. Remove the battery
and loosen the
start lever.
The weed brush does
not start or stops.
LED
L1
ashes green
[Fig. O4].
The battery is at. Charge the battery.
en
GAR_14820-20.960.02_2023-11-28.indd 14GAR_14820-20.960.02_2023-11-28.indd 14 28.11.23 13:4328.11.23 13:43
Bekijk gratis de handleiding van Gardena EasyWeed 1800/18V P4A, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
Merk | Gardena |
Model | EasyWeed 1800/18V P4A |
Categorie | Niet gecategoriseerd |
Taal | Nederlands |
Grootte | 46666 MB |