Fuxtec FX-BZ30 handleiding
Handleiding
Je bekijkt pagina 17 van 34
Manual_FX-BZ30_Int24_rev2
17
remove the staples from the relevant chamber (see point: Refilling the staples). Then press
the handle all the way down once. The tape gripper will then return to its original position
and you will not waste any staples by repeatedly trying to grip the tape.
• As soon as the tape has been gripped by the gripper, reload the staples into the chamber
provided. Please make sure that the two pointed ends of the staple point towards the black
handle when filling. If the staples are positioned incorrectly, the tape cannot be fastened.
• To tie branches together, hold the tying pliers against the branches as shown in picture 4.
Then push the handle all the way through. By means of the clamps, the ribbon is "stapled"
together and separated from the ribbon roll by the blade.
18. Refilling the staples
• To refill the staples, please push the black curved holder of the clamping device all the way
down and pull out the reloading pin together with the clamping spring to the back (see
picture 1 - circle marking).
• Fill up to 200 staples of type 604C into the chamber provided. Please pay attention to the
correct positioning of the staples. The pointed ends must point upwards towards the black
handle when filling, otherwise the staples will not grip the band when the binding pliers are
operated.
3
4
Bekijk gratis de handleiding van Fuxtec FX-BZ30, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Fuxtec |
| Model | FX-BZ30 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 14575 MB |
