Furuno MU-152 handleiding
Handleiding
Je bekijkt pagina 19 van 44
1. MOUNTING, WIRING
11
1.8 Wiring
Refer to the figure below and the interconnection diagram at the back of this manual to connect
cables.
Connector
How to secure composite signal cable
Secure composite cables with cable ties at the cable
clamps, to prevent disconnection.
1. Pass the cable tie (supplied) through the side of the
cable clamp.
2. Set the cable in the cable tie and fasten the cable tie.
3. Cut off excess cable tie with nippers.
ON
(Default setting)
OFF
CSH-5L/
8LMARK-2
FSV-30, etc.
CSH-5L/
8LMARK-2
FSV-30, etc.
FAR-15x8series
GD-300
FCV-2100, etc.
FAR-15x8series
GD-300
FCV-2100, etc.
The bottom of
the rear of the
monitor unit
Slide switch*
3
Slide switch*
3
RGB signal
3COX-2P-6C
5 m/10 m (option)
Digital signal
DVI-D/D S-LINK
5 m/10 m (option)
Digital signal
DVI-D/D S-LINK
5 m/10 m (option)
Composite signal
cable
Composite signal
cable
BRILL CTRL port*
4
CCD camera
DVD recorder
CCD camera
DVD recorder
IV-1.25 sq*
1
(local supply)
To ground
terminal on hull
MJ-A3SPF0013B-035C*
2
(3.5 m, standard supply)
*1
: Attach a crimp-on lug (inner dia. ø 4) for monitor unit side.
Connect the ground cable as short as possible.
*2
: The power cable has a fuse attached. The fuse holder is not waterproof.
*3
: - ON (upward): Allows external equipment to turn the monitor on/off
via digital signal.
- OFF (downward): Setting for analog RGB signal.
Note: Turn the slide switch off when you connect equipment to
both the DVI and RGB ports.
*4
: Remove the seal on the BRILL CTRL port to connect equipment.
Breaker for
12-24 VDC
Cable clamp
Cable tie
Bekijk gratis de handleiding van Furuno MU-152, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Furuno |
| Model | MU-152 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 5968 MB |
