Furman F1500-UPS E Handleiding (76 Pagina's)

Handleiding

Please read prior to battery replacement installation.

CAUTION! RISK OF EXPLOSION IF BATTERY IS REPLACED WITH AN INCORRECT TYPE.

CAUTION! When replacing batteries, replace with the same type of the original battery pack. (Part #BC-1500, Contact Furman to order replacement battery)

CAUTION! Before replacing batteries, remove conductive jewelry such as chains, wrist watches, and rings. High energy through conductive materials could cause severe

burns.

CAUTION! Do not dispose of batteries in a ﬁre. The batteries may explode.

CAUTION! Do not open or mutilate batteries. Released material is harmful to the skin, eyes, and environment. It may be toxic.

CAUTION! Do not attempt to replace batteries inside the battery carrier. Please refer battery replacement to a qualiﬁed service technician only!

3

Important Safety Instructions for Battery Replacement

BANKS

1 2 3 4

POWER MENU

WIRING

FAULT

BANKS

1 2 3 4

POWER MENU

PROTECTION

OK

BANKS

1 2 3 4

POWER MENU

PROTECTION

OK

F1500-UPS E FRONT PANEL INSTALLATION

1. Remove front panel from shipping

inserts.

2. Verify that the battery connectors are

connected, red-to-red, black-to-black (pic).

If not connected, perform steps 2 and 6 in the

BATTERY REPLACEMENT section

3. (Optional) Install the supplied rubber

end-caps to the sides of the front panel.

Push the curved edge of the end-cap into

the mating slots of the front panel.

4. Carefully align the front

panel connector latches with the

slots in the F1500-UPS E.

5. Gradually apply pressure to the

left and right ends of the front panel

until you hear the latches ‘click’

1. Power off and unplug the UPS. Remove the front panel. Remove the rubber end caps and pull up on the latch mechanism.

Once the latch mechanism stops, gradually pull the front panel off of the F1500-UPS E.

2. Remove the screw from the battery connector security plate to release

the battery connector.

3. Disconnect both the red and black connectors.

4. Remove the screws from the battery pack (part number BC-1500) and pull the battery pack out of the unit using the integrated handle.

5. Install the new battery pack into the unit. DO NOT ATTEMPT TO REPLACE THE BATTERIES

IN THE ORIGINAL BATTERY PACK. IMPROPER INSTALLATION CAN RESULT IN FIRE OR

BATTERY LEAKAGE.

6. Reconnect the red and black connectors.

WARNING! ALWAYS CONNECT RED to RED and BLACK to BLACK.

If the cable connectors do not snap together easily as RED to RED

and BLACK to BLACK, NEVER attempt to force them together or connect

RED to BLACK which will cause electrical sparking, shock, fire or

explosion! Call Customer Service for help.

8. Reinstall the front panel per the Front Panel Installation instructions.

MB1500/F1500-UPS BATTERY REPLACEMENT

The F1500-UPS E is shipped with the front panel unattached to ensure that no damage is caused during shipping. Before the F1500-UPS E can be used, the front panel must be installed.

7. Reinstall the battery connector

security plate.

Bekijk gratis de handleiding van Furman F1500-UPS E, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.