Full Boar FBAHC-019 handleiding
Handleiding
Je bekijkt pagina 11 van 17
11
KNOW YOUR PRODUCTSET UP & PREPARATIONSET UP & PREPARATION
Add air tool lubricate into the air tool once daily with minimal use, or twice a day
with heavy use. Only a few drops of oil at a time is necessary. Too much oil will
only collect inside the tool and will be noticeable in the exhaust cycle. Warning!
use only air tool oil to lubricate the tool.
Before connecting the tool, check the air compressor gauge to be sure it is
functioning within the proper range 6.2 bar (90 psi).
Note: The tool and air hose must have a
quick-connect hose coupling that allows all
pressure to be removed from the tool when
the coupling is disconnected.
1. Pull back the sleeve on female quick
connector hose coupling, insert male end
and release sleeve on quick connector.
Note: For best performance use 3/8” I/D
supply air hose.
WARNING! Ensure the tool is in the off position before connecting to the
air supply.
WARNING! Always use a coupling that discharges all the compressed
air in the tool at the time the fitting or hose coupling is disconnected.
Using a coupling that does not discharge the compressed air could cause
unintended operation and serious personal injury..
Connecting air supply
1. Wrap Teflon tape (not supplied) around the Nitto Style Fitting approximately 4
to 5 times to ensure a leak free seal.
2. Screw in Nitto Style Fitting to the air inlet of the Air Hammer Chisel.
3. Fasten the Nitto Style Fitting using a 14mm spanner (not supplied).
Bekijk gratis de handleiding van Full Boar FBAHC-019, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Full Boar |
| Model | FBAHC-019 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 2390 MB |
