Fulgor Milano F4MGK24S1 handleiding
Handleiding
Je bekijkt pagina 21 van 72
EN
17
D
E
A
B
C
After injectors replacement adjust the burner flame (see Low Flame
Adjustment paragraph).
Check the appearance of each burner’s flame at HILO settings, if
the flame appear too large or too small make sure that all steps
were completed correctly.
Convert the pressure regulator on LP position following the
illustration.
Converting Appliances for Use with NG Gas
If this appliance should be converted for use with gas NG (natural
gas), each of the following modifications must be performed.
1. Replace all injectors following the step described on page 16,
observe the number stamped on the side, this number codes the
orifice diameter and its correct burner location (following the
illustration of injectors position).
2. Convert the pressure regulator on LP position (following the
illustration of pressure regulator conversion).
3. Adjust the burner flame (see Low Flame Adjustment paragraph).
Check the appearance of each burner’s flame at HILO settings, if
the flame appears too large or too small make sure that all steps
were completed correctly.
Pressure regulator conversion
The appliances is designed for use with NG gas or LP gas. The
gas pressure regulator is supplied. It must be installed in the gas
way ahead of manifold entrance. It is pre-set for use with the gas
supplied with the appliances. For use with different gas must be
converted.
For the pressure regulator conversion following the below
instructions:
• Disconnect all electrical power, at the main circuit breaker or
fuse box.
• Shut off the gas supply to the cooktop by closing the manual
shut-off valve.
• Adjust the pressure regulator, by following the instruction (see
figure)
1. Unscrew the regulator cap
2. Unscrew the plastic conversion plug from the cap turn over and
screw back (wide section away from cap for LP and against cap
for NG) see figures below.
3. Replace the cap regulator.
PRESSURE REGULATOR CONVERSION
NG
LP
NG POSITION
PLUG
PRESSURE REGULATOR
LP/PROPANE POSITION
GASKET
CAP
Before replacing the regulator cap, check if the position
of plug is suitable for the gas
Bekijk gratis de handleiding van Fulgor Milano F4MGK24S1, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Fulgor Milano |
| Model | F4MGK24S1 |
| Categorie | Fornuis |
| Taal | Nederlands |
| Grootte | 9846 MB |
