Fulgor Milano F4MGK24S1 handleiding
Handleiding
Je bekijkt pagina 20 van 72
EN
16
6 - Conversion for LP or NG Gas
Converting Appliance for Use with LP Gas
WARNING
Conversion is to be performed by a AUTHORIZED
SERVICER (or other qualified agency) in accordance with the
manufacturer’s instructions and all codes and requirements of the
authority having jurisdiction. Failure to follow instructions could
result in serious injury or property damage.
The qualified agency performing this work assumes responsibility
for this conversion.
WARNING
Before proceeding with the conversion, shut off the gas
supply to the appliance prior to disconnecting the electrical
power
If this appliance should be converted for use with gas LP (propane
or butane), each of the following modification
must be performed:
Gas conversion label (aluminium) to be placed on the back of the
appliance, near the data plate, after conversion has been carried
out;
Replace injector on (one ring flame or stacked
burners)
1. Remove the grates and burner cups.
2. Remove aluminum gas spreader.
3. Loosen injector by turning 9-32” (7 mm) nut driver counter
clockwise.
4. Install the injectors supplied with this appliances in the
appropriate burner. The injectors have small number stamped
on the side, this number codes the orifice diameter and its correct
burner location (see figure on page 18).
5. Turn clockwise to tighten (tighten to a torque of 15 to 20 inch-lbs).
6. Replace all parts following the reverse order.
7. Save the orifices removed from the appliance for future use.
Replace injectors on (two rings flame burner)
1. Remove the grates and burner caps (A).
2. Remove gas spreader (B).
3. Remove the orifice cover screw (C). Remove the orifice cover.
4. The center orifice (D) can be removed by using a 9-32” nut
driver. (Counter clockwise.)
5. The other two orifices (E) can be removed by using a 9-32”
box wrench. (Counter clockwise.)
6. Install the orifices supplied with this appliance in the
appropriate burner. Each orifice has a number stamped on the
side, which identifies the orifice diameter. (See the paragraph
for the orifices to use in each burner position.)
7. Turn clockwise to tighten. (Tighten to a torque of 15 to 20
inch-lbs.)
8. Replace all parts following the reverse order.
9. Save the orifices removed from the appliance for future use.
Bekijk gratis de handleiding van Fulgor Milano F4MGK24S1, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Fulgor Milano |
| Model | F4MGK24S1 |
| Categorie | Fornuis |
| Taal | Nederlands |
| Grootte | 9846 MB |
