Frigidaire GMOS1968SS handleiding
Handleiding
Je bekijkt pagina 12 van 52
Installation Instructions
Cabinet Front
Cabinet Bottom Shelf
Filler Block
Microwave Ov
en Top
Attach the microwave oven to the top cabinet
.
Equivalent to
Depth of
Cabinet
Recess
3
MOUNT THE MICROWAVE OVEN
Self-Aligning Screw
4
2
R
otate front of oven
up against cabinet
bottom.
Insert a self-aligning screw through top center
cabinet hole. Temporarily secure the oven by
turning the screw at least two full turns after
the threads have engaged. (It will be
completely tightened later.) Be sure to keep
power cord tight. Be careful not to pinch the
cord, especially when mounting flush to
bottom of cabinet.
N
OTE: When
mounting the
microwave oven, thread
power cord through hole in
bot
tom of top cabinet. Keep
it tight throughout Steps
1–3. Do not pinch cord or lift
ove
n by pulling cord.
Li
ft microwave,
tilt it forward, and
hook slots at back
bottom edge onto
four lower tabs of
mounting plate.
1
CHECK BLOWER PLATE
Blower Plate
• Place the microwave in its upright position,
w
ith the
top of t
he unit facing up.
• Check to see that the blower plate is
correctly installed on the unit.
USE TOP CABINET TEMPLATE
FOR PREPARATION OF TOP
CABINET
• Read the instructions on the TOP CABINET
TEMPLATE.
• T
ape it underneath the top cabinet.
• D
r
ill
the holes, following the instructions on
the TOP CABINET TEMPLATE.
C
A
U
T
I
ON: Wear safety goggles when drilling
holes in the cabinet bottom.
You need to drill holes for the top support
screws and a hole large enough for the power
cor
d to fit through.
NOTE:
Adjust top
template accordingly if the microwave
is being spaced out from the wall due to cabinet
depth (including cabinet doors) of more than 13"""''.
FOR
EASIER INSTALLATION AND PERSONAL
SAFETY, WE RECOMMEND THAT TWO PEOPLE
INSTALL THIS MICROWAVE OVEN.
IMPORTANT: Do not grip or use the handle or heat
shield during installation. Do not remove the
cardboard spacers between the heat shield and
door.
NOTE: If your cabinet is metal, use the nylon
grommet around the power cord hole to prevent
cutting of the cord.
NOTE: We recommend using filler blocks if the
cabinet front hangs below the cabinet bottom shelf.
IMPORTANT: If filler blocks are not used, case
damage may occur from overtightening screws.
A2.
A3.
A4.
EN-11
Bekijk gratis de handleiding van Frigidaire GMOS1968SS, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Frigidaire |
| Model | GMOS1968SS |
| Categorie | Magnetron |
| Taal | Nederlands |
| Grootte | 10247 MB |
