Frigidaire GDSP4735AF handleiding
Handleiding
Je bekijkt pagina 20 van 28
8. TROUBLESHOOTING
8.1 Factors affecting performance
Water Pressure
The hot water line to dishwasher must
provide water pressure between 20 and 120
psi.
Low Water pressure may occur when laundry
or showers are in operation. If you experience
poor wash performance you may need to wait
until water use is reduced before starting
dishwasher.
Water Temperature
Hot water is needed for best dishwashing and
drying results. Water entering dishwasher
should be at least 120°F (49°C) to give
satisfactory results.
To check water temperature entering
dishwasher:
• Turn on hot water faucet nearest
dishwasher for several minutes to clear
cool water from pipes.
• Hold a candy or meat thermometer in the
water stream to check the temperature.
• If temperature is below 120°F (49°C),
have a qualified person raise the hot water
heater thermostat setting.
IMPORTANT
Before starting a cycle, run hot water to
clear cool water from pipe.
Power Alert
The dishwasher stops temporarily if a period
of abnormal voltage occurs while the
dishwasher is running.
NOTE
A power abnormality is when the voltage
is either too low or too high to properly
run appliances or electronic devices. A
power outage is when no power is
available to run any electronic devices.
During this time the UI displays 2 dashes and
a POWER message with a lit START LED.
Once the voltage returns to normal, the
dishwasher automatically resumes the wash
cycle if the door has not been opened. If the
door is opened during the abnormal power
condition, press start and close the door
within 4 second for the cycle to resume when
power returns to normal.
The POWER indicator in the status window
turns off once power is returned to normal.
If power becomes abnormal during cycle
selection, the START LED goes out and the
status window displays the POWER message
and 2 dashes.
NOTE
The buttons on the control panel may be
disabled when voltage is too low for the
dishwasher to operate.
Resume the wash after power outage
When power is restored, the control panel
lights up for 3 seconds while the dishwasher
starts up. After startup completes, the wash
settings of where the cycle left off display on
the control panel and status window. The
POWER message displays in the status
window and the START LED blinks to
indicate power was out. The control panel
stays in this state until any button other than
CANCEL is pressed. Pressing CANCEL
cancels the cycle.
To resume a wash cycle after a power
outage, open the door to show where the
20 ENGLISH
Bekijk gratis de handleiding van Frigidaire GDSP4735AF, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Frigidaire |
| Model | GDSP4735AF |
| Categorie | Vaatwasser |
| Taal | Nederlands |
| Grootte | 2732 MB |
