Frigidaire FRTD1830AS handleiding
Handleiding
Je bekijkt pagina 15 van 28
CAUTION!
To avoid property damage:
• User stainless steel braided tubing
for the water supply line. Do not
use water supply tubing made of
1/4"
plastic. Plastic tubing greatly
increases the potential for water
leaks, and the manufacturer will not
be responsible for any damage if
you use plastic tubing for the
supply line.
• Do not install water supply tubing in
areas where temperatures fall
below freezing.
• Chemicals from a malfunctioning
softener can damage the ice
maker. If the ice maker is
connected to soft water, ensure
that the softener is maintained and
working properly.
IMPORTANT
Ensure your water supply line
connections comply with all local
plumbing codes.
6.2 You will need
• Basic tools: adjustable wrench, flat-
blade screwdriver, and Phillips™
screwdriver.
•
Access to a household cold water line
with water pressure between
30 and
100 psi.
• A water supply line made of stainless
steel tubing. To determine the length of
tubing needed, measure the distance
from the ice maker inlet valve at the
back of the appliance to your cold
water pipe. Then add approximately 6 ft
(1.8 m) to ensure you can move the
appliance for cleaning.
• A shutoff valve to connect the water
supply line to your household water
system. Do not use a self-piercing type
shutoff valve.
• Do not reuse compression fitting or use
thread seal tape.
NOTE
Check with your local building
authority for recommendations on
water lines and associated materials
prior to installing your new refrigerator.
Depending on your local/state building
codes, Frigidaire recommends:
•
for homes with existing valves its
Smart Choice® water line kit
5304437642 with a 6 ft stainless
steel water line.
• for homes without an existing
valve, we recommend Smart
Choice® water line kit 5304493869
with a 6 ft polyline waterline.
Please refer to Frigidaire.com for
more information.
6.3 Installing the water supply
line
NOTE
These instructions do not cover after
market ice maker installation.
Instructions in after market ice maker
kit should be used.
To connect water supply line to ice maker
inlet valve:
1. Disconnect refrigerator from electric
power source.
2. Place end of water supply line into sink
or bucket. Turn on water supply and
flush supply line until water is clear.
Turn off water supply at shutoff valve.
3. Remove plastic cap from water valve
inlet and discard cap.
4. Depending on the tubing you use:
• Copper tubing - Slide brass
compression nut, then ferrule
(sleeve) onto water supply line.
Push water supply line into water
valve inlet as far as it will go (
1/4" /
6.4 mm). Slide ferrule (sleeve) into
valve inlet and finger tighten
compression nut onto valve.
Tighten another half turn with a
wrench; do not over tighten.
• Braided flexible stainless steel
tubing - The nut is already
assembled on the tubing. Slide nut
onto valve inlet and finger tighten
nut onto valve. Tighten another half
turn with a wrench; do not over
tighten.
ENGLISH 15
Bekijk gratis de handleiding van Frigidaire FRTD1830AS, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Frigidaire |
| Model | FRTD1830AS |
| Categorie | Koelkast |
| Taal | Nederlands |
| Grootte | 2913 MB |
