Friedrich ZoneAire Select PZE09K3SB handleiding

Airco

Friedrich

37 pagina's

PDF beschikbaar

Handleiding

J. STARTUP AND OPERATION

J.2 Air Flow Selection and Adjustment

VENTILATION CONTROL

The ventilation control lever is located at left

side of unit, behind front panel.

NOTE:The vent door shipping hardware must

be removed before using vent control lever.

See Installation Instructions.

When set at close POSITION, only the air inside

the room is circulated and ﬁltered.

When set at open POSITION, some outdoor

air will be drawn into room. This will reduce

heating or cooling efﬁciency.

EnergyTip : Keep the vent control at POSITION.

Room air will be ﬁltered and circulated.

Figure J.2.1 (Ventilation Control Location)

ADJUSTING AIR DIRECTION

To adjust air direction:

1.Remove front panel.

2.Remove louver screws that hold louver insert in place (from back side of front panel). See Fig. J.2.2

3. Turn louver insert and rotate 180 See Fig. J.2.3

4.Replace louver insert.

5.Replace screws and front panel.

Louver screws

Figure J.2.2 (Backside of Front Panel)

Air discharge upward

Air discharge outward (Default)

Figure J.2.3 (Adjusting Louvers)

Vent Control

(Pull lever through label

to operate.)

Open position Close position

Bekijk gratis de handleiding van Friedrich ZoneAire Select PZE09K3SB, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.