Friedrich WallMaster WCVT12B30A handleiding

Airco

Friedrich

90 pagina's

PDF beschikbaar

Handleiding

48 48

Coils & Chassis

NOTE: Do not use a caustic (alkaline) or acidic cleaning agent on coils or base pan. Use a biodegradable cleaning agent and de greaser.

The use of harsh cleaning materials may lead to deterioration of the aluminum ns or the coil end plates.

The indoor coil and outdoor coils and base pan should be inspected periodically (annually or semi-annually) and cleaned of all debris

(lint, dirt, leaves, paper, etc.) as necessary. Under extreme conditions, more frequent cleaning may be required. Clean the coils with and

base pan with a coil comb or soft brush and compressed air or vacuum. A low pressure washer device may also be used; however, you

must be careful not to bend the aluminum n pack. Use a sweeping up and down motion in the direction of the vertical aluminum n

pack when pressure cleaning coils.

NOTE

: It is extremely important to insure that none of the electrical and/ or electronic parts of the unit get wet when cleaning. Be

sure to cover all electrical components to protect them from water or spray.

Decorative Front

Use a damp (not wet) cloth when cleaning the control area to prevent water from entering the unit, and possibly damaging the electronic

control.

The decorative front and the cabinet can be cleaned with warm water and a mild liquid detergent. Do NOT use solvents or hydrocarbon

based cleaners such as acetone, naphtha, gasoline, benzene, etc.

The indoor coil can be vacuumed with a dusting attachment if it appears to be dirty. DO NOT BEND FINS. The outdoor coil can be gently

sprayed with a garden hose.

The air lter should be inspected periodically and cleaned if needed by vacuuming with a dust attachment or by cleaning in the sink using

warm water and a mild dish washing detergent. Dry the lter thoroughly before reinstalling. Use caution, the coil surface can be sharp.

Fan Motor & Compressor

The fan motor & compressor are permanently lubricated and require no additional lubrication.

Wall Sleeve

Inspect the inside of the wall sleeve and drain system periodically (annually or semi-annually) and clean as required. Under extreme

conditions, more frequent cleaning may be necessary. Clean both of these areas with an antibacterial and antifungal cleaner. Rinse both

items thoroughly with water and ensure that the drain outlets are operating correctly. Check the sealant around the sleeve and reseal

areas as needed.

Blower Wheel / Housing / Condenser Fan / Shroud

Inspect the indoor blower and its housing, evaporator blade, condenser fan blade and condenser shroud periodically (yearly or bi-yearly)

and clean of all debris (lint, dirt, mold, fungus, etc.). Clean the blower housing area and blower wheel with an antibacterial / antifungal

cleaner. Use a biodegradable cleaning agent and de greaser on condenser fan and condenser shroud. Use warm or cold water when

rinsing these items. Allow all items to dry thoroughly before reinstalling them.

Electrical / Electronic

Periodically (at least yearly or bi-yearly) inspect all control components: electronic, electrical and mechanical, as well as the power

supply. Use proper testing instruments (voltmeter, ohmmeter, ammeter, wattmeter, etc.) to perform electrical tests. Use an air

conditioning or refrigeration thermometer to check room, outdoor and coil operating temperatures.

Air Filter

To ensure proper unit operation, the air lter should be cleaned at least monthly, and more frequently if conditions warrant. The unit must

be turned off before the lter is cleaned.

ROUTINE MAINTENANCE

Bekijk gratis de handleiding van Friedrich WallMaster WCVT12B30A, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.