Friedrich Hazardgard SH20M30B handleiding

Airco

Friedrich

90 pagina's

PDF beschikbaar

Handleiding

SH20N50AT and SH24N30AT Adhere to the following certications:

CERTIFIED PER STD. NO. ANSI/ISA 12.12.01,2013

PER STD. NO. IEC 60079-0, 6th Edition PER STD. NO. IEC 60079-15, 4th Edition

PER STD. NO. CAN/CSA C22.2 NO. 213-M1987

PER STD. NO. CENELEC EN 60079-0: 2012 + A11: 2013

PER STD. NO. CENELEC EN 60079-15: 2010

CERTIFICATION DEMKO 15 ATEX 1364X II 3 G Ex ec nA nC IIC T4 Gc

IECEX UL15.0051X DEMKO 15 ATEX 1364X

SH20N50AT & SH24N30AT

Specic Conditions of Use:

• Provision shall be made to prevent the rated voltage being exceeded by

the transient disturbances of more than 140% of the peak rated voltage.

• The equipment must be installed only for use in locations providing

adequate protection against the entry of solid foreign objects or water

capable of impairing safety.

• Only permanently wired cables may enter the cable glands. The user

shall provide for the required strain relief.

• Degree of protection will be safeguarded only when sealing and cable

entry ttings are properly tted. To ensure proper protection, all wiring

connections and conduit passageways must have the appropriate ATEX/

IECEx certied plug or cable gland.

• Cable Glands shall be mounted into the enclosure in such a way that

they are mechanically protected against impact force.

• To avoid the buildup of electrostatic charge, regularly clean the unit with

a damp cloth.

• The appliance is not to be used by persons (including children) with

reduced physical, sensory or mental capabilities, or lack of experience

and knowledge, unless they have been given supervision or instruction.

Children to be supervised not to play with the appliance.

• The enclosure with a coating must not be used in areas affected by

charge-producing processes, mechanical friction and separation

process, electron emission (e.g. in the vicinity of electrostatic coating

equipment), and pneumatically conveyed dust.

Electrical Ratings:

Refrigerant System Ratings:

NOTICE: To maintain IP44 protection, the Hazardgard

unit must be installed in accordance to the installation

instructions stated in this document.

The following additional previous editions of Standards noted under the “Standards” section of this

Certicate where applied to integral Components as itemized below. There are no signicant safety re-

lated changes between these previous editions and the editions noted under the “Standards” section.

Junction Box, Part No. 25. 10 16

08, manufactured by Rose.

IEC 60079-7:2006-

07, IEC 60079-31:

ATEX & ICEX Standards Specic to Models SH20N50AT & SH24N30AT

ATEX/IECEx Model Number Rated Voltage,

Frequency

Rated Cooling

Amps

Compressor

RLA,LRA

Motor

FLA

Motor

MCA MOP

SH20N50AT 240/220, 50Hz 11.6 9.4, 50 2 1/3 13.25 20

SH24N30AT 230/208, 60 Hz 11.8 10.2, 52 1.5 1/4 14.25 20

ATEX/IECEx Model Number R-410a Charge, oz High-Side Design Pressure (PSIG) Low-Side Design Pressure (PSIG)

SH20N50AT-B 40.7 600 300

SH24N30AT-A 46.8 600 300

Bekijk gratis de handleiding van Friedrich Hazardgard SH20M30B, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.