Friedrich Hazardgard SH20M30B Handleiding (90 Pagina's)

Handleiding

21

Chassis Wiring and Preparation (Non ATEX)

PROVIDED HARDWARE

1 JUNCTION BOX

2 MOUNTING LEGS

2 LEG SCREWS

2 HOLE COVERS

1 STAINLESS STEEL

GROUND SCREW

2 SCREWS

1 SHEET METAL SCREW

Figure 27

Figure 28

STEP2 Remove and discard the threaded bushing wire protector from the conduit connector on the side panel of the control

compartment. Install eld supplied cable gland as required. Strip the wires approximately 1/2 inch (13 mm).

STEP1 Remove the junction box, cover and screws from the shipping position underneath the fan motor (See Figure 7). Install one

junction box mounting leg in the upper left position facing the rear of the junction box. (Figure 27)

Bekijk gratis de handleiding van Friedrich Hazardgard SH20M30B, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.