Flex PP 40 12 handleiding
Handleiding
Je bekijkt pagina 19 van 257
PP 40 12/PP 110 18-EC
19
Overview (Fig. A)
Different devices are described in these
instructions. The illustrated cordless tube
press may differ in detail from the one which
you purchased.
1Handle
2 LED green – operating status
3 Start button
4 LED red – fault
5 LED worklight
6 Release button
7 Retaining bolt
8 Pressing jaws/intermediate jaws
9 Slot for battery
10 Li-ion battery (2.5 Ah/5.0 Ah/8.0 Ah)
11 Battery release button
12 State of charge indicator
13 LED blue – Bluetooth
Instructions for use
WARNING!
Remove the battery before carrying out any
work on the cordless tube press.
Before initial operation
Unpack the cordless tube press and check
that there are no missing or damaged parts.
NOTE
The batteries are not fully charged on
delivery. Prior to initial operation, charge the
batteries fully. Refer to the charger
operating manual.
Inserting/changing the battery
Fig. B:
Push the charged battery into the
cordless tube press until it engages fully.
Fig. C:
To remove, press the release buttons (1.)
and pull out the battery (2.).
CAUTION!
When the device is not in use, protect the
battery contacts. Loose metal parts may
short-circuit the contacts; risk of explosion
and fire!
Battery charge level (Fig. D)
Press the button to check the charge
level via the battery charge indicator
LEDs.
The indicator goes out after five seconds.
If one of the LEDs flashes, the battery must
be recharged. If none of the LEDs light up
after the button is pressed, the battery is
faulty and must be replaced.
Behaviour of the cordless tube press
when the battery is discharged
At the start of a pressing operation, the system
checks whether the battery charge is sufficient
to complete the pressing operation.
If this is not the case, the cordless tube press
will not start. The green LED (2) flashes.
If the green LED (2) flashes after a pressing
operation, this pressing operation has still
been carried out correctly.
The battery must be recharged before the
next pressing operation.
Switching on and off
Fig. E:
Press the start button once to switch on.
The green LED lights up.
The cordless tube press switches off
after approx. 30 s if it is not being used.
Tips for a long battery service life
CAUTION!
–
Never charge batteries at temperatures
below 0 °C or above 40 °C.
–
Do not charge batteries in environments
with high air humidity or ambient
temperature.
–
Do not cover batteries and the charger
during the charging process.
–
Pull out the charger mains plug at the
end of the charging process.
The battery and charger heat up during the
charging process. This is perfectly normal!
Lithium-ion batteries do not exhibit the
established "memory effect". Nevertheless,
a battery should be completely discharged
before charging, and the charging process
should always be fully completed.
Bekijk gratis de handleiding van Flex PP 40 12, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Flex |
| Model | PP 40 12 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 24956 MB |
