Ferrofish Pulse 16 MX handleiding
Handleiding
Je bekijkt pagina 14 van 28
14
Both modes transfer the same amount of channels (32), but the 96k frame
mode has the advantage, that the receiver can distinguish the SMUX/1 and
SMUX/2 modes, so it can switch automatically between 48kHz and 96kHz
for example. 96k frame is the preferred setting if the receiver can recognize
it.
MADI short frame (MX or MADI option only)
The most common MADI configuration is 64 channels (SMUX/2: 32
channels, SMUX/4: 16 channels). This uses the full bandwidth of the MADI
interface. When enabling the short frame option, the PULSE16 will send
only 56 channels (SMUX/2: 28 channels, SMUX/4: 14 channels) instead of
64 channels. This option corresponds to an older standard, where the
bandwidth of the missing eight channels is used to be able to change the
speed of the MADI signal within some percent up or down.
Delay Compensation (MX or MADI option only)
When connecting several PULSE16 units in daisy-chain the MADI data will
be routed thru the first unit to the second unit and so on. This results in a
small delay of the data on the second, third and fourth unit. To compensate
this delay you have to tell the PULSE16 which order it is inside the MADI
chain:
• Single: only one unit connected.
• 1 of 4: first device in the MADI chain
• 2 of 4: second device in the MADI chain
• 3 of 4: third device in the MADI chain
• 4 of 4: fourth device in the MADI chain
MIDI control (MX or MADI option only)
Here you can set from which port the PULSE16 should receive remote
commands:
• From the 5-pin-MIDI input only
• From the MIDI-over-MADI input only.
• From both sources.
Bekijk gratis de handleiding van Ferrofish Pulse 16 MX, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Ferrofish |
| Model | Pulse 16 MX |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 4365 MB |
