Ferrofish A32pro handleiding
Handleiding
Je bekijkt pagina 16 van 24
16
A32pro Series Manual: Main Menu > Setup
BNC SETTINGS
The BNC wordclock input is internally terminated in the hardware with a 75 Ohm resistor. In normal
daisy- chain wiring (wordclock out of unit#1 to wordclock in of unit 2, wordclock out of unit#2 to
wordclock in of unit#3, etc.), you should always leave this termination switched on if your FERROFISH
device is the last unit in the wordclock chain. In case of cabling with BNC T-connectors, the
termination should be switched off. In this case, the termination is usually done by an extra
termination BNC end-cap.
DEVELOP MODE
In DEVELOP mode, external developers can test their own plug-ins and software developments on our
hardware platform. However, this requires a Software Development Kit (SDK) from FERROFISH.
Without this kit, an error message appears on the screen.
This is normal and does not indicate a malfunction of the unit.
VISUAL SETTINGS
Here you can determine the behavior of the encoder LED,
the LED in the power button and the brightness of the displays.
Power LED: Determines the state of the POWER button's LED
when switched off:
Off, pulsating (xfade) or dimly glowing (dimmed)
Alert Ring: Here you determine the behaviour of the white light corona of the encoder in the event of an alert: On, one of three flashing modes.
(flashing 1-3) or one of four pulsating appearances (xfader 1-4). An "off/off" mode does not exist here for safety reasons - to switch off the alert
LED entirely, disable this option in the ALERT menu.
In the left screen, the general brightness of the displays can be set as well as the display behaviour of the brightness related to time:
Ramp up when event 15s: The brightness is ramped up to the maximum brightness when the display is pressed and after 15s it is ramped
back to the brightness set in the upper row.
Keep dimmed: The brightness of the display is kept at the level selected above.
A32pro Series Manual: Main Menu > Setup > Settings
CONFIG / MISC. CONFIGURATION
In the CONFIG menu, the unit can be reset to the factory settings or the so-called Las Vegas
mode can be started.
Factory Reset: This resets the unit and sets all settings to default.
ATTENTION: THE FACTORY RESET RESETS ALL SETTINGS OF THE UNIT INLCUDING THE PRESETS!
So please make a note of any important settings before resetting the unit.
Las Vegas Mode: Displays a wave-like movement of the I/O meters for demo purposes.
Bekijk gratis de handleiding van Ferrofish A32pro, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Ferrofish |
| Model | A32pro |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 7127 MB |
