Feelworld 4K12X handleiding
Handleiding
Je bekijkt pagina 22 van 68
re-pair the code of the new remote control. If the code pairing has been unsuccessful,
the red LED light flashes for 20 seconds and then goes out, stop the code pairing and
go to sleep; at this time, press any key to wake up and re-pair the code.
After the code is successfully matched, you need to select the camera address to
control it
2）Clear Code Data
Press the "Settings" key + "#" key from light off to flashing, the receiving end is
powered off and then powered on. The LED is off, indicating that the paired data is
cleared successfully
3）Enter Sleep Mode and Wake Up
If there is no operation in the working state, it will immediately enter the sleep mode,
and press any key to wake up.
3.2.1
IR Remote Control
1. Standby Key
After 3S long press, the camera will step into standby mode.
Long press 3S again, the camera will self-test again and back
to HOME position. (Note: If power-on mode is turned on and
Preset 0 is set, and there is no operation within 12s, it will
automatically point to the specified preset position.
2. Camera Address Selection
Select the camera address which wants to be controlled
3. Number Key
Set or run 0-9 presets
4,*,# Key
Key combination use
5. Focus Control Key
Auto Focus: Enter into auto focus mode.
Manual Focus: The camera focus mode is manual
Switch the camera focus mode to manual focus by pressing
[focus +] or [focus -] to adjust.
Bekijk gratis de handleiding van Feelworld 4K12X, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Feelworld |
| Model | 4K12X |
| Categorie | Bewakingscamera |
| Taal | Nederlands |
| Grootte | 7490 MB |