Handleiding
Je bekijkt pagina 7 van 24
- 7 -
INSTALLATION INSTRUCTIONS
General Display Case Location
The case must be located where it is not subjected to the direct rays of the sun, heating ducts, grills,
radiators, or ceiling fans, nor should it be located near open doors or main door entrances.
Removing Case From Shipping Skid and General Installation
CAUTION:
Do not push against the top glass, front glass, ends, doors or
door frames when removing the case from the skid or moving the case. Case
damage or glass breakage could result.
1. Remove crate top and sides and note missing or damaged items as explained in the pre-installation
procedures outlined above.
2. Move the case as near as possible to the final location and before removing it from the shipping skid.
3. Remove the (8) screws that secure the case to the shipping skid.
4. Prepare cabinet according to instructions in this section that pertain to your model.
5. Lift the case off of skid and into required position. Only lift the case from the lifting/shipping brackets
located on each end of the case
6. Fasten each case to cabinet with the (2) #12 screws supplied.
7. Rout electrical cord according to instructions in this section that pertain to your model.
8. Case must be sealed to the counter using a NSF listed sealant.
Cleaning
For initial setup, clean the case as outlined in the “Weekly Cleaning” section of this manual.
Bekijk gratis de handleiding van Federal ERR4828SS, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Federal |
| Model | ERR4828SS |
| Categorie | Koelkast |
| Taal | Nederlands |
| Grootte | 2341 MB |
