Falmec Mizar 90 handleiding

Afzuigkap

Falmec

80 pagina's

PDF beschikbaar

Handleiding

CLEANING OF INTERNAL PARTS

It is forbidden to clean electrical parts, or parts related to the motor inside the hood, with liquids or solvents.

Do not use abrasive products. All these operations are to be carried out after having disconnected the equipment from the electrical mains

power supply.

METAL ANTIGREASE FILTERS

The metal anti-grease lters are there to contain suspended grease particles: deposited on the lters, these feed on any ames released

when cooking, generate unpleasant odours, and compromise the passage of air, thus reducing suction performance of the hood.

For this reason, it is advised to frequently wash the metal lters (at least once a month) leaving them to soak in boiling water and dish

washing liquid for 1 hour, taking care not to bend them. Do not use corrosive, acid or alkaline detergents.

Rinse them well and wait for them to be completely dry before reassembling them.

Washing in a dishwasher is permitted, however, it may cause the lter material to darken: to reduce the possibility of this problem from

happening, use low-temperature washes (55°C max.).

Use the handle to take out the metal anti-grease lters (see instructions G on page 6). Carry out operations in reverse order

to insert them.

ACTIVE CARBON FILTERS

Active carbon lters have the function of retaining odours in the air ow passing through them. The air, puried by running many times

through the lter, is recirculated into the kitchen. Active carbon lters cannot be washed and are to be immediately replaced every 3-4

months

(depending on the frequency of use of the hood).

Dispose of the active carbon lters in compliance with the regulations in force in the country of use.

To change active carbon lters, take out the metal anti-grease lters (see instructions G on page 6) and follow the instruc-

tions H on page 6.

DISPOSAL AFTER END OF USEFUL LIFE

This symbol on products and/or in accompanying documents means that electrical and electronic products used must not be disposed of with general domestic

waste. For personal treatment, recovery and recycling, you are kindly asked to take these products to designated waste collection points where they will be accepted

freely. Alternatively, in other countries, it is possible to take products back to the local dealer and purchase a new similar product. Proper disposal of these products

contributes to saving valuable resources and avoid potential negative eects on personal health and the environment, which may be caused by inappropriate disposal

of waste. You are kindly asked to contact your local authorities for further information regarding the designated waste collection points nearest to you. Penalties for

improper disposal of such waste can be applied in compliance with national regulations.

INFORMATION REGARDING DISPOSAL IN EU COUNTRIES

The EU Directive with regard to WEEE has been implemented dierently by each nation, therefore, should you wish to dispose of this equipment, we advise you to

contact the local authorities or the dealer to ask for the correct method of disposal.

INFORMATION REGARDING DISPOSAL IN OTHER NONEU COUNTRIES.

This symbol is only valid in the European Union: if you wish to dispose of this product in other countries, we advise you to contact your local authorities or dealer to

ask for the proper method of disposal.

Bekijk gratis de handleiding van Falmec Mizar 90, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.