Extron VSW 2VGA A handleiding
Handleiding
Je bekijkt pagina 4 van 12
4
VSW2VGAA • User Guide (Continued)
• Autoswitching —
NOTES:
• Autoswitch mode must be disabled when daisy chaining VSW2VGAA switchers. If the autoswitch mode is
enabled, the switchers cannot be daisy chained.
• RGsB and RsGsBs inputs and outputs occur in manual mode only.
• Autoswitching requires TTL level sync on pin 13 of the 15-pin HD connector.
Pins 1, 2, and Ground when jumpered and shorted together (as shown at right) turn the autoswitching mode on.
When the autoswitching mode is on, the switcher automatically switches to the input that has an active sync
signal.
If both inputs have an active sync signal present, input 2 is selected, and the input 2 LED indicator lights. If no
active sync signal is present, the input 1 LED indicator still lights to indicate that the unit is still powered on.
NOTE: When autoswitch mode is active, both daisy chaining and the front panel input toggle switch are disabled,
and the input cannot be manually switched. Any attempt to toggle the switch while the switcher is in this
mode results in the flashing of the currently active input LED indicator. Contact closure is also disabled while in
autoswitch mode.
Setting the VSW2VGAA Jumpers
NOTE: If you plan to use the VSWIAAP and create a daisy chain configuration, you must configure the switchers before
installing them in a rack or furniture and making connections.
Daisy chaining VSW2VGAA switchers requires you to check, set or both internal jumpers in the switcher.
1. If applicable, disconnect all power to the switcher and any attached devices.
2. Remove the two screws on each side of the switcher (see figure6). Remove the four connector nuts on the front panel of the
switcher. Lift the top cover off of the switcher.
VSW 2VGA A
INPUT 1
2
1
INPUT
2
Remove (4)
Connector Nuts
Remove (4)
Screws
Figure 6. Removing the Cover
3. Set the jumpers for the switcher (see figure7).
4. Set the cover in place and resinstall the screws removed
in step 2.
JMP4
JMP3
JMP5
JMP6
FRONT PANEL
JMP1
EXTRON 20-881-
nn
x
ER:-
yyyyyyyy yyyy
Figure 7. VSW2VGAA Jumper Locations
There are ve jumpers, numbered JMP1, and JMP3 through JMP6, that control daisy chaining on the VSW2VGAA switcher (see
figure7). Both data and power must be daisy chained from one switcher to another.
6
7
AUTO-SW
CONTACT
1 2
Bekijk gratis de handleiding van Extron VSW 2VGA A, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Extron |
| Model | VSW 2VGA A |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 2286 MB |
Caratteristiche Prodotto
| Kleur van het product | Zwart |
| Gewicht | 300 g |
| Breedte | 109 mm |
| Diepte | 76 mm |
| Hoogte | 25 mm |
