Handleiding
Je bekijkt pagina 13 van 39
a. Use a small screwdriver to pry and separate
the insert from the locking arm.
b. Repeat this process for the remaining two
locking arms.
c. Rotate all three locking arms back into the
speaker.
7. Configure the cable conduit access plate
and captive screw connector.
a. If two conduits are being used, knock
out the alternate knockout.
i. Place the head of the screw driver on
the notch of the knockout.
ii. Tap the back of the screwdriver until
the knockout pops out.
b. Loosen the two side cable conduit access
plate screws and remove the plate before
wiring the speaker.
Figure 5. Prying off the Locking
Arm Insert
Alternate
Knockout
Cable/Conduit
Access Plate
Screws (2)
Cable
Clamp
Figure 6. Removing the Cable Conduit Access Plate
c. Configure the cable conduit access plate:
When not using conduit: Route the speaker wires through the cable clamp.
When using conduit: Remove the cable clamp and install the conduit into the
plate opening. Secure the conduit to the plate with the locking nut and pull the
speaker wires from the conduit.
NOTE: The plate has an alternate hole available by removing the knockout. See
step 7a to remove the knockout.
d. Strip 0.2 inches (5 mm) from the wire ends.
5
6
SF 3C LP and SF 3CT LP User Guide • Installation 7
Bekijk gratis de handleiding van Extron SF 3CT LP, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Extron |
| Model | SF 3CT LP |
| Categorie | Speaker |
| Taal | Nederlands |
| Grootte | 6313 MB |
Caratteristiche Prodotto
| Kleur van het product | Black, White |
| Gewicht | 1600 g |
| Breedte | 226 mm |
| Diepte | 226 mm |
| Hoogte | 112 mm |
