Extron FOX3 SR 301 handleiding
Handleiding
Je bekijkt pagina 25 van 58
FOX3SR 301 and FOX3SR311 Scaling Receivers • Operation 17
Front Panel Lockout (Executive Mode)
The FOX3 scaling receivers have a front panel security lock that locks out all front panel
controls. It can be enabled via PCS (see the FOX3SR301/311Using PCS Help File) or via
the front panel buttons.
To enable or disable front panel lockout via the front panel buttons —
• Enable — Press and hold the down arrow button and the MENU button simultaneously
for 5seconds. When enabled, Executive Mode Enabled displays on the screen for
2seconds and the front panel is locked out.
• Disable — Press and hold the down arrow button and the MENU button simultaneously
for 5seconds. When disabled, Executive Mode Disabled displays on the screen for
2seconds and the front panel is unlocked.
If the user tries to use the front panel controls when the executive mode is enabled,
Executive Mode Enabled displays for 2 seconds.
Source Information OSD
The FOX3 scaling receivers can overlay the source name in a bidirectional or unidirectional
connection to the FOX3 Matrix. The OSD settings can be customized via SIS commands on
the FOX3 Matrix and the FOX3 scaling receiver. This feature is disabled by default and must
be enabled to use it. For information on configuring the Source Information OSD, see the
FOX3 Matrix Series User Guide, available at www.extron.com.
NOTE: The firmware on the FOX3 Matrix must be v1.02.0003-b001 or higher for this
feature to operate.
Reset Modes
The rear panel Reset button initiates three levels of resets. Use a pointed stylus, ballpoint
pen, or small screwdriver to access the recessed button.
See the Reset Modes table on page18 and figure15 on page18 for a summary of
the resets.
ATTENTION:
• Review the reset modes carefully. Some reset modes delete all user loaded content
and revert the device to default configuration.
• Analysez minutieusement les différents modes de réinitialisation. Certains modes de
réinitialisation suppriment l’intégralité du contenu chargé de l’utilisateur et remettent
l’appareil au mode de configuration par défaut.
Perform resets of the unit as follows (see figure15):
RESET
RESET
RESET RESET
RESET RESET
RESET
RESET
Press and hold
the Reset button.
Mode 1
Apply power
to the FOX3.
Release Reset button.
Release, then immediately
press and release again.
Reset LED flashes, then stays on.
Mode 4
Reset LED flashes twice.
Press and hold
for 6 seconds.
Release, then immediately
press and release again.
Reset LED flashes, then stays on.
Mode 5
Reset LED flashes three
times.
Press and hold
for 9 seconds.
Figure 15. Resets
15
Bekijk gratis de handleiding van Extron FOX3 SR 301, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Extron |
| Model | FOX3 SR 301 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 10927 MB |
