Extron FOX Rx AV handleiding
Handleiding
Je bekijkt pagina 17 van 34
E
Alarm (see figure 3 on page 5) — When connected to an alarm, this 3.5
mm 2-pole captive screw connector gives a warning when light signals have
been disconnected, lost, or broken.
See the Attention on page 6 for important information about preparing and
connecting wires to captive screw connectors.
The alarm pins, labeled 1 and 2, (see the figure at right) on the rear panel of the
FOX Tx/Rx AV act as a short when activated. They do not produce any discrete
on or off voltage signals but act as an internal relays that either connect or
disconnect external alarm circuits.
For the FOX Tx AV, the alarm state is activated when link 2 is absent. For the
FOX Rx AV, the alarm state is activated when link 1 is absent.
When power is lost, the alarm state is activated for both units.
F
Fiber optic cable connector (see figure 3) — An LC duplex SFP connector
links the transmitter and receiver. An LED above each port lights when a signal
is received. The optical Rx port of the receiver lights when a signal from fiber link
1 reaches the receiver. The optical Rx port or the transmitter lights when a signal
from link 2 reaches the transmitter.
WARNING:
AVERTISSEMENT :
• The FOX Tx/Rx AV outputs continuous invisible light (Class 1 rated),
which may be harmful and dangerous to the eyes; use with caution.
• Le FOX Tx/Rx AV émet une lumière invisible en continu (conforme
à la classe1) qui peut être dangereux pour les yeux, à utiliser avec
précaution.
• Do not look into the rear panel fiber optic cable connectors or into
the fiber optic cables themselves. Plug the attached dust caps into
the optical transceivers when the fiber optic cable is unplugged.
• Ne regardez pas dans les connecteurs de câble fibre optique
sur le panneau arrière ou dans les câbles fibre optique eux-
mêmes. Branchez les protections contre la poussière dans
l’ensemble émetteur/récepteur lorsque le câble fibre optique est
débranché.
Link 1 connects the Tx port of the transmitter and the Rx port of the receiver. It carries
video, audio and/or data output from the transmitter to the receiver.
Link 2 is optional. It connects the Tx port of the receiver with the Rx port of the transmitter.
It only carries the responses to RS-232 commands and is not required for transmitting video
and audio signals.
However, if link 2 is not enabled, the ability to configure the system through SIS commands
is limited by the lack of communication from the receiver to the transmitter. All commands
issued through the transmitter are valid but responses to status queries may return invalid
data.
Signals may be transmitted 2 km (6561 feet) over multimode (MM) fiber and 30 km (18 miles)
over singlemode fiber. An MM transmitter must always be connected to a MM receiver and
an SM transmitter can only be connected to a SM receiver.
1 2
ALARM
RxTx
OPTICAL
RxTx
OPTICAL
FOX Tx AV
FOX Rx AV
FOX Tx/Rx AV • Panel Features and Connections 9
Bekijk gratis de handleiding van Extron FOX Rx AV, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Extron |
| Model | FOX Rx AV |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 5900 MB |
