Extron FOX II T HD 4K handleiding
Handleiding
Je bekijkt pagina 15 van 41
FOX II T HD 4K Transmitter • Installation and Operation 7
H
Fiber optic ports and LEDs (see figure 2 on page 5)—
WARNING: The FOX II T HD 4K outputs continuous invisible light (Class 1 rated),
which may be harmful to the eyes; use with caution. Plug the attached dust cap
into the optical transceiver when the fiber optic cable is unplugged.
AVERTISSEMENT :
Le FOX II T HD 4K émet une lumièr
e invisible en continu
(conforme à la classe1) qui peut être dangereux pour les yeux, à utiliser avec
précaution Branchez la protection contre la poussière dans l’ensemble
émetteur/récepteur lorsque le câble fibre optique est débranché.
NOTES:
•
Ensur
e that you use the proper fiber cable for your transmitter. Typically,
singlemode fiber has a yellow jacket and multimode cable has an orange or
aqua jacket.
•
Only one fiber optic cable, transmitter
-Tx-to-receiver-Rx, is required for video,
audio, and RS-232 and IR signal transmission. But, if you connect only one
fiber optic cable:
• The digital video signal output by the receiver is not HDCP-compliant.
• You will not receive RS-232 reports or return audio from the controlled
device.
• To receive responses from the controlled device and for HDCP compliance,
you must install both fiber optic cables.
1
Tx (required) — For all one-way video, audio, and serial
Tr
ansmitter
to
Receiver
OPTICAL
Rx
Tx
LINK
LINK
OPTICAL
Rx
Tx
LINK
LINK
1
122
communications from the transmitter to the receiver, connect a
fiber optic cable to the Tx LC connector.
Connect the opposite end of this fiber optic cable to the Rx LC
connector on a FOX II R DP 4K receiver or to any other compatible
Extron FOX II device.
2
Rx (optional) — For one-way return audio and serial
communications from the receiver to the transmitter, connect a
fiber optic cable to the Rx LC connector.
Connect the opposite end of this fiber optic cable to the Tx LC
connector on a FOX II R DP 4K receiver or to any other compatible
Extron FOX II device.
Tx Link and Rx Link LEDs — When lit, the link is active (light is
sensed).
I
Power input — Plug a standard IEC power cord into this connector to connect the
transmitter to a 100 VAC to 240 VAC, 50-60 Hz power source. The lit LED indicates
power is applied.
Bekijk gratis de handleiding van Extron FOX II T HD 4K, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Extron |
| Model | FOX II T HD 4K |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 5917 MB |
