Euro Appliances ECT600ACG handleiding

21 pagina's
PDF beschikbaar

Handleiding

Je bekijkt pagina 17 van 21
17
current temperature is higher than a certain value, to reduce the heating level of
the cooking zone currently, and resumes the heating level after the temperature
drops.
Residual heat protection: When the whole appliance stops heating, the digital
tube of the relative heating zone will display high temperature warning symbol ”,
indicating that cooking surface temperature is too high, please do not touch to
avoid getting burned.
Safety cut-off protection:For the models with plug,when cut off after 1S at any
time,the voltage between L/N of the plug should fall to below safe voltage range.
13.PCB board fault codes and solutions
When a PCB board failure occurs, the timer digital tubes on the display panel always
display the fault code, and all the burners that are being heated stop heating, and
automatically return to the shutdown state after 1 minute. For the burners that have
been worked, the corresponding digital tube continues to display the high temperature
warning sign " ". When the fault code appears, please refer to the scheme in the
following table to solve.
How to use the hot plate
Put the pot in center of the heating zone, Turn the knob clockwise and anticlockwise to
turn on the hob.
High temperature indication lamp:
When the glass plate is too hot, the high temperature indication lamp will light up, don’t
touch the glass plate until the indication lamp goes out.
Shut down:after using,please turn the knob to “OFF”,the hob will stop heating.
Caution!
Ensure the heating plate is clean-a soiled zone does not transfer all of the heat.
Fault code
Type of fault
Solution
E1
The display board does not
receive the signal of power
supply board.
The communication line failure
of power supply board or display
board can cause communication
anomalies.
Replace the display board first. If
the fault persists, replace the
power supply board.
E2
The power supply board
does not receive the signal
of display board.
E3
Power supply board relay
failure
Replace the power supply board.

Bekijk gratis de handleiding van Euro Appliances ECT600ACG, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.

Productinformatie

MerkEuro Appliances
ModelECT600ACG
CategorieFornuis
TaalNederlands
Grootte4213 MB