ETA Sonar Aqua Plus 3232 90000 handleiding

Stofzuiger

ETA

64 pagina's

PDF beschikbaar

Handleiding

OUTPUT HEPA FILTER REPLACEMENT (A2)

To remove the filter, follow the procedure indicated in Fig. 5. To fit a new filter

in the vacuum cleaner, proceed in reverse order.

TAKING OUT WATER TANK (K2)

When removing the water tank K2, follow the procedure shown on Fig. 11.

Empty excessive water from the tank. Install the water tank using the reverse procedure.

VII. CLEANING AND MAINTENANCE

Notes

– For hygienic purposes we recommend that you empty the container and clean

the filters after each use.

– Maximum suction power can be achieved when the filters are clean and the dustbag

is empty.

–

Every time you empty the dust container, we recommend that you also clean the filters.

– When you are vacuuming very fine dust, the filter pores might get clogged.

This reduces the air flow and reduces the suction power. In such a case, the filters

need to be cleaned even though the container is not full yet.

Clean the surface of the vacuum cleaner and adaptor with a soft wet cloth.

Do not use any rough and aggressive detergents!

Accessories

After any vacuuming it is recommended to check visually the brushes or collectors

for possible impurities. If there are some impurities, remove them.

Floor nozzle with rotary brush (G)

Remove any dirt (especially hair, animal hairs, etc.) stuck to the brush.

To make cleaning easier, the brush can be removed (Fig. 7).

Small direct-drive turbo brush (H)

Remove any dirt (especially hair, animal hairs, etc.) stuck to the brush.

To make cleaning easier, the brush can be removed (Fig. 8).

Dust container (D)

Clean the surface and the inside of the container D with a soft wet cloth. Blow out separator

D2. Plastic component D3 can be rinsed in owing water. Allow all parts to dry completely.

HEPA filter (A2, D4)

Shake out the input HEPA lter A2/D4 gently, or blow it out. If the HEPA lter is very dirty,

you can rinse it under running lukewarm water. Allow it to dry out properly.

Caution

–

Do not clean the filters with any aggressive washing or cleaning detergents or hot water.

– Washing HEPA filters in water means deterioration of their filtration capacity.

The filter cannot be washed more than three times. After that, a new filter needs to be

purchased.

– HEPA filters should be replaced 2x a year.

– The filters are not dish-washer safe.

–

Failure to clean or replace the filters as required may cause a defect of the vacuum cleaner!

33 / 63

Bekijk gratis de handleiding van ETA Sonar Aqua Plus 3232 90000, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.