ETA Lucas 4343 90000 handleiding
Handleiding
Je bekijkt pagina 25 van 52
EN - 25
EN
Clipping with hair comb attachment B3 (fig. 4, 7, 8, 9)
1) You may also use the attachment cut length switch for finer cut setting
3 - 7
mm (fig. 7).
2) Make sure that the flat part of the comb is always in full contact with the scalp to obtain an even result.
3) Move the clipper slowly over the crown from different directions to achieve an even result.
4) Always move the clipper against the direction of hair growth.
5) Make overlapping passes over the head to ensure that all hair that should be cut has been cut.
Trimming facial hair a mustache
1) Choose the appropriate attachment B1+B3 depending on your desired length of cut.
2) Wet facial hair / mustache slightly and brush it before trimming.
3) Mark a facial hair line with the trimmer and cut off the hairs exceeding this line from the outer perimeter. Trim
carefully over a brush to achieve an even cut of the mustache. If you prefer using your finger as a guide,
proceed accordingly.
Trimming nose hair (fig. 4, 10)
1) Make sure nasal passages are clean.
2) Place nose, ear attachment B2 on
appliance
.
3) Switch the
appliance
on and insert the tip of the attachment into one nostril.
4) Slowly move the tip in and out while turning it around at the same time in order to remove unwanted hair.
For best results, make sure the side of the tip is firm against skin. This will reduce the tickling effect that
can occur during trimming of nose hair.
5) Turn off
appliance
. Wipe attachment clean after each use.
Trimming ear hair (fig. 4, 10)
1) Clean outer area of ear and ear canal. Make sure it is free of wax.
2) Nose, ear attachment B2 should be on the
appliance
3) Switch the
appliance
on and move the tip softly around the edge of ear to remove hairs extending beyond
the outer ear.
4) Carefully insert the tip into outer ear canal.
5) Turn off
appliance.
Wipe attachment clean after each use.
IV. MAINTENANCE (FIG. 11-13)
Turn off the appliance before each maintenance, or unplug the adapter from the electric socket! Do
not use rough and aggressive detergents! Wipe the trimmer surface with a wet soft cloth. Clean the
attachments with the brush attached C1.
Cleaning under running water
• Switch the appliance on and rinse the shaving head A4 under hot running water until all residues have
been removed. You may use liquid soap without abrasive substances. Rinse off all foam and let the
shaver run for a few more seconds.
• Next, switch off the shaver, and let it dry. Unfold the shaving head using the A5 button. and let it dry.
• If you regularly clean the shaver under water, then once a week apply a drop of light machine oil onto the
shaving head / trimmer.
Bekijk gratis de handleiding van ETA Lucas 4343 90000, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | ETA |
| Model | Lucas 4343 90000 |
| Categorie | Scheerapparat |
| Taal | Nederlands |
| Grootte | 4458 MB |
