EPEVER DR3210N handleiding
Handleiding
Je bekijkt pagina 4 van 34
1
www.solarv.de
Copyright © 2021 SolarV GmbH
1. Overview
1.1 Information & Features
DuoRacer MPPT charge controller is made for charging two batteries (shown as main battery
(BATT1) and starter battery (BATT2) below) at the same time in a solar system. This controller
supports multiple main battery (BATT1) types, including Sealed, Gel, Flooded, LiFePO4, and Li-
NiCoMn, which is suitable for RV, Camper, Boat, and so on. The device recognizes the starter
battery (BATT2) system voltage automatically, and trickle charges the battery when the
conditions are satisfied.
The controller adopts the advanced MPPT control algorithm,which will minimize the maximum
power point loss rate and loss time,also fast track the maximum power point(MPP) of the PV
array, and obtain the maximum energy from solar array under any conditions. The energy
utilization in the MPPT solar system is increased by 20-30% compared with PWM charging
method.
When there is no manual operation for a long time, and the charging conditions cannot be
reached, the controller will turn to low-power mode, which reduces the loss and battery power
waste to enhance the products life. The system parameters are shown and set by LED/LCD or
the MT11 remote meter (Accessory).
The AES control signal of the car refrigerator is built in the controller, which will supply the
surplus solar power to the refrigerator to avoid energy waste. The controller comes with IP33
protection level, which is waterproof and dustproof. Multiple protection features, including
battery overcharge protection, over discharge protection, and reverse connection protection
of the PV and battery, which effectively ensure the solar system safety, stability, and lifetime.
Features：
Maximum Power Point Tracking technology with ultra-fast tracking speed and the
tracking efficiency is no less than 99.5% guaranteed
Advanced MPPT control algorithm to minimize the MPPlost rate and lost time
The wider range of the MPP operation voltage to improve the PV module utilization
Auto control function of charging power & charging current limitation(BATT1)
High quality and low failure rate components of ST, TI and Infineon to ensure the
product life
Digital circuit control of adaptive three-stage charging mode to enhance BATT1 life.
BATT1 type can be set via LED/LCD.
Product runs into the low-power mode when there is no manual operation for a long
time, and charging conditions are not satisfied (PV<5V).
100% charging and discharging in operationenvironmental temperature range.
Bekijk gratis de handleiding van EPEVER DR3210N, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | EPEVER |
| Model | DR3210N |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 5618 MB |
