Enabot EBO Air 2 handleiding
Handleiding
Je bekijkt pagina 5 van 32
Technical Specifications
Supported Memory Expansion
File Format
Recharge Method
Resolution
Battery
Camera
Product Model
Power
Product Name
2450mAh
Infrared Automatic Recharge
16G ~ 256G
MP4、JPG
2K
137° wide angle, supports night vision
EBO Air 2
EBO Air 2 Companion Robot
5V 2A
Charging Station Instructions
1. Secure the power cable into the base's power cord alignment slot to ensure that there is no gap when the
charging station is stable on the ground.
2. Remove the transparent protective film from the anti-slip adhesive on the base's bottom. Place the charging
station against a wall, ensuring the back is flush with the wall and the base sits flat on the ground.
3. If the charging station is powered OFF, the indicator light will remain off. If the charging station is powered ON
and the robot is not on the charging station, the indicator light will be green and solid. If the charging station is
powered ON and the robot is on the charging station, the indicator light will be red and solid.
4. Keep the area 1.5 meters in front and 1.0 meter on each side of the charging station clear of obstacles. This
ensures the robot can easily return for charging.
5. While the robot is charging, you can check the charging status via the robot's status/expression light or the App.
NOTE: If you need the robot to return to the charging station quickly, use the App to guide it to an open area about 2 meters in front of
the station, then press the automatic recharging button.
＞1.0m
＞1.0m
＞1.5m
Networking Instructions
1. After the robot is turned on, the status/expression light “ ” will flash, indicating that that it has entered QR
code binding mode.
3. Wait for the robot to emit a successful binding tone. The App will display a prompt indicating that the robot
has been successfully connected to the network.
2. Install the Yibao Robot App. Open the App, then click the “ ” in the upper left corner to add your robot, and
follow the on-screen instructions to prepare the robot for network setup. Enter the correct Wi-Fi name and
password and ensure your router is connected to the Internet. Once the App generates a QR code, hold it about
15cm away from the robot's camera for scanning.
Tips:
a. Place the robot on the charging station while connecting to the network to ensure it has sufficient power.
b. Ensure the robot operates within a strong Wi-Fi signal range. Avoid obstructions such as walls or floors, and ensure the router is not
too far away to prevent the App from freezing or disconnecting.
~15cm
03 04
Bekijk gratis de handleiding van Enabot EBO Air 2, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Enabot |
| Model | EBO Air 2 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 5718 MB |
