Handleiding
Je bekijkt pagina 6 van 323
6 Safety - ENGLISH
Safety during installation
WARNING!
• Always use personal protective equipment (gloves etc.) during installation, maintenance and repair.
There is a risk of injury.
• Do not damage the refrigerant circuit.
• Do not plug in the product if it is damaged.
• When positioning the product, ensure the power cord and power plug are not trapped or damaged. A
damaged power plug may overheat and cause a fire.
• When positioning the product, ensure the power plug is accessible.
• Do not install the product in a location with direct sunlight.
• Do not install the product near heat sources such as stoves, fires or heaters.
• Do not install the product in areas with moisture, rain or frost.
• Keep ventilation openings outside the product clear of obstruction.
• Do not install the product without sufficient space and air ventilation around the product. This leads to
overheating.
• Do not install the product close to radiators or cookers.
• This product must be placed on a level surface of hard material that is the same height as the rest of the
flooring.
• The surface that the product is installed on should be strong enough to support a fully loaded product. It
is recommended to install this product on a surface that withstand moisture.
• Adjust the feet until all feet make contact with the floor and the product is level. This prevents the product
from moving, tipping over and risk of injury.
• Do not install the back of the product too close to a wall. There is a risk of fire if the compressor gets
overheated.
• When positioning the product, the space above the product must be minimum 100 mm, and the product
must be placed against a side wall with a clearance of at least 100 mm to allow for air circulation and to
prevent overheating. It is advisable to be 75 mm from the back to the wall to avoid touching or catching
warm parts (compressor, condenser) to prevent the risk of fire.
• This product performs well within the climate class SN, N, ST, T. The product may not work properly if it is
exposed to temperatures above or below temperature ranges spanning from 10°C to 43°C for a long
period.
WARNING!
• Do not connect the product to the power socket if the product is damaged. Contact the retailer from
which you purchased the product.
• Use a dedicated power socket, meaning that the power socket must not be shared with other products.
• Do not locate multiple portable socket outlets or portable power supplies behind the product.
• Make sure to connect the power plug to an earthed socket. Check carefully to ensure that your socket is
properly and reliably earthed.
• Do not use extension cords and do not lengthen the power cord.
• After positioning the product, it is recommended to wait at least 4 hours before connecting the product to
the mains. This allows the oil to flow back in the compressor.
• If the fluctuation of voltage in the installation area exceeds the single phase alternating current of
220~240V/50Hz, use an AC automatic voltage regulator of more than 350W.
NOTE!
Contact Elvita support if you need help with the installation of your product.
Bekijk gratis de handleiding van Elvita CFB6420V, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Elvita |
| Model | CFB6420V |
| Categorie | Vriezer |
| Taal | Nederlands |
| Grootte | 31869 MB |
