Elvita CDM2451X handleiding
Handleiding
Je bekijkt pagina 40 van 291
40 Installation - ENGLISH
1. Lift up the hose to the tap.
2. Screw the connector onto the threads of the tap.
Connect the safety supply hose to a tap
Use the safety supply hose to ensure that the flow of water stops if the hose is damaged. The hose is double-walled and
the air space between the inner and the outer corrugated hose fills up with water if the hose is damaged. .
CAUTION!
• If the water pipes are new or have not been used for an extended period of time, let the water run to
make sure that the water is clear. This precaution is necessary to avoid the risk of the water inlet
becoming blocked and damaging the dishwasher.
• If your sink has a spray jet fed by a hose that is connected to the same water line as the dishwasher the
hose could burst. If your sink has one, it is recommended that the hose be disconnected and the hole
plugged.
1. Lift up the hose to the tap.
2. Screw the connector onto the threads of the tap.
Connect to an external drain
CAUTION!
• Avoid bending, kinking or squashing the drain hose.
• Do not immerse the end of the drain hose into the waste water. Immersing the hose could hamper the
drainage and cause waste water to go back into the dishwasher again.
• Do not use a drain hose extension longer than 4metres. Otherwise the cleaning performance of the
dishwasher could be impaired.
• The drain pipe connection must be at a height of less than 100cm from the base of the dishwasher.
Otherwise you must drain excess water into a suitable container held lower than the sink.
Bekijk gratis de handleiding van Elvita CDM2451X, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Elvita |
| Model | CDM2451X |
| Categorie | Vaatwasser |
| Taal | Nederlands |
| Grootte | 34272 MB |
