Elsner Remo KNX RF handleiding
Handleiding
Je bekijkt pagina 31 van 38
29 Remote control programming
Remote Control Remo KNX RF • Version: 14.09.2021 • Technical changes and errors excepted.
7. Remote control programming
Addressing of the device at the bus.
Menu: Programming mode
The equipment is delivered with bus address 15.15.255. A different address can be pro-
grammed in the ETS by overwriting the address 15.15.255. For this purpose, the program-
ming mode on the remote control must be activated.
(1) Swipe the screen from the top edge downwards to open the settings menu. Keep in
mind that the menu can be blocked from opening (object block).
(2) Tap Programming mode.
(3) Switch the programming mode On. Start the programming in the ETS.
With the active programming mode, the menu item lights up red (similarly to programming
LED on other devices), and the display remains on (automatic switch-off inactive).
Time point 1: End of Time 1, beginning of Time 2,
Movement command
Release after Time 1 runs out
but before Time 2 is expired: Stop
Release after Time 1+2 runs out: Movement to the end position
Control mode Comfort mode
Behaviour when a button is operated:
Push-button is pressed and
released before expiry of Time 1 = stop/step
held for longer than Time 1 = up or down
released between Time 1 and 1 + 2 = stop
released Time 1+2 = no more stop
Time 1 (in 0.1 sec) 0 ... 50; 4
Time 2 (in 0.1 sec) 0 ... 50
123
Bekijk gratis de handleiding van Elsner Remo KNX RF, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Elsner |
| Model | Remo KNX RF |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 3349 MB |
