Elsner KNX VOC/TH-UP Touch weiß handleiding

Niet gecategoriseerd

Elsner

68 pagina's

PDF beschikbaar

Handleiding

27 Parameter setting

Sensor KNX VOC/TH-UP Touch • Version: 30.11.2021 • Technical changes and errors excepted.

Specify when the current control variables of the controller are to be sent to the bus.

Periodic sending is safer, in case a message does not reach a recipient. You may also

set up periodical monitoring by the actuator with this setting.

The status object reports the current status of the control variables (0% = OFF,

>0% = ON) and may for example be used for visualisation, or to switch off the

heating pump as soon as the heating is switched off.

Then define the type of control. Heating and/or cooling may be controlled in two lev-

els.

Behaviour of the blocking object with value • 1 = Block | 0 = release

• 0 = block | 1 = release

Blocking object value

before 1st communication

0 • 1

Send control variable • on change

• on change and periodically

from change (in % absolute) 1...10; 2

Cycle

(if sent periodically)

5 s • ... • 5 min • … • 2 h

Send status objects • on change

• on change to 1

• on change to 0

• on change and periodically

• on change to 1 and periodically

• on change to 0 and periodically

Cycle

(if sent periodically)

5 s • ... • 5 min • … • 2 h

Type of control • Single level heating

• Dual-level heating

• Single-level cooling

• Single-level heating + single-level cooling

• Dual-level heating + single-level cooling

• Dual-level heating + dual-level cooling

Bekijk gratis de handleiding van Elsner KNX VOC/TH-UP Touch weiß, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.