Elsner KNX VOC/TH-UP Touch weiß handleiding

Niet gecategoriseerd

Elsner

68 pagina's

PDF beschikbaar

Handleiding

10 Addressing of the device at the bus

Sensor KNX VOC/TH-UP Touch as of software 0.1.0 • Version: 30.11.2021 • Technical changes and errors excepted.

After the bus voltage has been applied, the device will enter an initialisation phase

lasting a few seconds. During this phase no information can be received or sent via the

bus.

4. Addressing of the device at the bus

The device is supplied with the bus address 15.15.255. You can program another

address into the ETS by overwriting the 15.15.255 address or by teaching via the

programming button.

5. Display and operation at the device

Detailed specifications for the display and the use of the push buttons are set in the

ETS.

Basically the display can show a two-row or three-row text (e. g. for measured values)

or a temperature controller. You can switch between the two types by pressing one of

the buttons, if this has not been disabled in the ETS.

5.1. Mode display and manual temperature

controller

Depending on the ETS setting selected, the mode display will only display show the

current target value, or the base target value setting with scale display. The manually

adjustable range can be set in the ETS.

The following display options are available:

Fig. 3

Mode display with current target value and/or base

target value

Fig. 4

Mode display with scale display for adjusting the base

target value.

The control position in the image reads "Base target

value reduced".

Fig. 5

Mode display with scale display and number.

Shows the set target value change.

The control position in the image reads "Base target

value reduced to 1.0°".

Bekijk gratis de handleiding van Elsner KNX VOC/TH-UP Touch weiß, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.