Elsner Corlo Touch KNX handleiding
Handleiding
Je bekijkt pagina 19 van 148
17 Description
Display Corlo Touch KNX • Status: 30.08.2021 • Technical changes and errors reserved.
1.8. Load individual images
1.8.1. Images for screensaver
The setting of the screen saver is described in the manual chapters
2.4. Display (ETS) and 3.4.4. Screen saver (Display)
Images that are shown as the screensaver must be stored on a micro SD card. In order
that the system can recognize the SD card, carry out a reset in the menu after inserting
it
Settings> System > Reset
This is not necessary if the card was inserted before booting the system. The card must
remain in the device.
Store images in the given size in a corresponding folder on the top level of the SD card:
Images for individual image display ("diafix" folder) must have a 4-digit numerical
sequence so that they can be called up in the ETS and in the menu (0001...9999).
1.8.2. Images for image display
Images can be called up as a stationary display (e. g. welcome screen). In contrast to
the screensaver, the touch function is disabled while a stationary image is displayed.
Image type Resolution File format Folder name
Images for slide show 320 × 240 pixels .jpg (RGB mode) slideshow
Images for
individual image
display
320 × 240 pixels .jpg (RGB mode) diafix
The proximity sensor reacts only when a larger object moves
from the front into the detection area. It is best to move the flat
hand towards the display so that the sensor reacts quickly.
Fig. 9 Proximity sensor
1 Proximity sensor Sender
2 Proximity sensor Receiver (and light sensor for adaption
of the screen brightness)
2 1
Bekijk gratis de handleiding van Elsner Corlo Touch KNX, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Elsner |
| Model | Corlo Touch KNX |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 16939 MB |
