Handleiding
Je bekijkt pagina 66 van 81
UM600410 Rev C page 66 of 81
User Manual –I-Series 4.0
About Android Debug Bridge (ADB) control
Elo I-Series 4.0 supports debugging via Wi-Fi/Ethernet or using the USB cable.
Note: For USB debugging, use a USB Type A to Type A cable.
Set I-Series 4.0 to (Developer)
• Enter Android Settings → About tablet → Build Number.
• Tap Build Number 7 times to enter developer mode.
• Go back to the Settings → System → Advanced and you will see “Developer Options”.
• From Developer options on- screen display, enable the option called “USB debugging”.
To connect via Wi-Fi
Ensure that your computer is online and not behind a firewall.
• Find the IP address (by going to Settings → Network & Internet → Wi-Fi →Tap the active connection → Advanced→ IP Address.
• On your host computer, use the command ADB connect <IP address> to be able to perform ADB actions.
To connect via USB, perform the following steps
• Ensure the USB cable is not connected to the I-Series 4.0.
• From the settings, enter Developers Options
• Turn on the “Enable USB Debugging” option
• Plug USB cable (type A) side into the I-Series device and (type A) to host PC.
• In the host PC, input “ADB devices” to check if the Elo I-Series 4.0 serial number shows up. If it is
there, then you have connected successfully.
Bekijk gratis de handleiding van ELO E389883, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | ELO |
| Model | E389883 |
| Categorie | Monitor |
| Taal | Nederlands |
| Grootte | 8160 MB |
