Handleiding
Je bekijkt pagina 65 van 81
UM600410 Rev C page 65 of 81
User Manual –I-Series 4.0
General-purpose Input/Output (GPIO) Support
The I-Series 4.0 supports a GPIO which can be used to connect to peripherals such as a motion sensor.
Elo has an optional GPIO cable (PN: E211544) with flying leads so that it is easy for users to connect their
own peripherals.
Pinout of the GPIO cable (PN: E086398):
Red Wire: Pin 1 → 5 Volt output connection
White Wire: Pin 2 → Input connection 1
Green Wire: Pin 3 → Input connection 2
Two Black Wires: Pin 4 and Pin 5 are tied to ground
5V, 200mA is the max voltage and current available via this GPIO port.
G-Sensor
All I-Series 4.0 units are equipped with a g-sensor and will rotate the video based on the orientation of the device.
USB – C Settings
All I-Series 4.0 device supports USB – C video, audio and touch via the USB- C cable.
The 15.6 and 22in I-Series 4.0 device can also support power up to an Elo 1502L Touch monitor via the USB – C cable when using the optional Elo 90W
power supply.
To enable video output, enter the developer options and click on USB and DP configuration.
• Default mode is DP (4 lanes) & HS-USB (allows for video output and USB2.0 speeds)
• Note Ethernet speeds will be limited to USB2.0 speeds
• User can change to SS-USB only to allow for higher USB and Ethernet speeds. There is no video output in this mode.
• If the USB protocol is changed, please reset the I-Series Device.
Bekijk gratis de handleiding van ELO E389883, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | ELO |
| Model | E389883 |
| Categorie | Monitor |
| Taal | Nederlands |
| Grootte | 8160 MB |
