Elna eXcellence 790PRO handleiding
Handleiding
Je bekijkt pagina 137 van 148
135
Problems and Warning Signals
If a buzzer sounds and the visual touch screen shows a warning sign, follow the guidance below.
Warning Sign Cause Try this
The start/stop button is pressed with the foot control
connected.
Disconnect the foot control.
The foot control is out of order. Contact the service center
or the store from whom the
machine was purchased.
The machine will stop if the buttonhole is sewn without
lowering the buttonhole lever.
Lower the buttonhole lever
and start the machine again.
The twin needle key is pressed when the twin needle sign
is indicated on the visual touch screen.
Replace the twin needle with
a single needle and press
the OK key.
The machine is started with the feed dog lowered. Raise the feed dog unless
you want to sew with the
feed dog lowered.
The needle plate is removed.
The needle plate is not properly attached to the set
position.
Attach the needle plate.
Check if the needle plated is
attached properly.
Press down the needle plate
with your nger to snap it
into the set position.
The needle plate is removed with the needle plate release
dial.
Turn the needle plate
release dial at set position.
Attach the needle plate.
The machine is halting due to overload.
Wait for at least 15 seconds
to restart. Remove tangled
threads around take-up lever,
hook race and automatic
thread cutting mechanism.
Bekijk gratis de handleiding van Elna eXcellence 790PRO, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Elna |
| Model | eXcellence 790PRO |
| Categorie | Naaimachine |
| Taal | Nederlands |
| Grootte | 39891 MB |
