Elna eXcellence 580+ handleiding
Handleiding
Je bekijkt pagina 19 van 88
17
o
!0
v Put the bobbin on the bobbin winder spindle.
t Bobbin
y Bobbin winder spindle
b Pass the thread to the bobbin.
Hold the thread with both hands and wind it around
the bobbin clockwise several times.
n Insert the thread into one of the slits i of the ange
plate u and pull the thread to cut.
u Flange plate
i Slit
m Push the bobbin to the right. The bobbin mark
appears on the LCD screen.
o Bobbin mark
, Start the machine.
Stop the machine when the bobbin is fully wound and
stops spinning.
Return the bobbin winder spindle to its original
position.
. Remove the bobbin. Cut the thread with bobbin thread
cutter B !0.
! 0 Bobbin thread cutter B
NOTE:
For safety purposes, the machine will automatically
stop 1.5 minutes after starting bobbin winding.
Winding the bobbin
z Pull the thread from the spool.
Hold the thread with both hands and pass the thread
into the guide slot q.
q Guide slot
x Be sure that the thread is pulled down under the
notch w and into the space below the guide slot as
shown.
w Notch
c Draw the thread to the left and forward around the
thread guide e.
Draw the thread to the rear and to the right around
and under the guide plate r.
Firmly pull the thread to the right while holding it with
both hands.
e Thread guide
r Guide plate
NOTE:
Set the speed control slider at the fastest position (refer
to page 9).
v b
n m
, .
r
e
z x
q
w
c
t
y
i
u
Bekijk gratis de handleiding van Elna eXcellence 580+, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Elna |
| Model | eXcellence 580+ |
| Categorie | Naaimachine |
| Taal | Nederlands |
| Grootte | 0 MB |
