Handleiding
Je bekijkt pagina 8 van 52
8
PREPARING THE CABINET FOR INSTALLATION:
• The product cannot be installed above cooling
appliances, dishwashers, heaters, ovens, washing ma-
chines and dryers.
• Create the cut-outs in the cabinet before inserting the
hob and carefully remove any shavings or sawdust.
ICAUTION
Failure to install screws and fasteners in accordance with
these instructions may result in electrical hazards.
IIMPORTANT
Use a single-component adhesive sealant (S), which withs-
tands temperatures up to 250°; before installation, thorou-
ghly clean the surfaces to stick and eliminate any substan-
ce that may compromise adhesion, (e.g. release agents,
preservatives, fats, oil, dust, traces of old adhesives, etc.);
the adhesive should be uniformly spread all around the
outside of the frame; after sticking, leave the adhesive to
dry for about 24 hours.
s
s
1/4”
3-Wire Cable from Home Power Supply to 3-Wire Cable
from Cooktop
IMPORTANT: Use the 3-wire cable from home power su-
pply in the U.S. where local codes do not allow grounding
through homes and recreational vehicles, new construc-
tion, and in Canada.
A
B
E
C
D
H
F
G
A
. Cable from home power supply
B. Black wires (Phase)
C. Green or yellow-green ground wires (ground)
D. Conduit with 3-Wire from cooktop
E. Junction box
F. UL listed wire connector (not supplied)
G. Red wires (Phase)
H. UL listed or CSA approved conduit connector (not
supplied).
1. Connect the 2 black wires together using the UL listed
wire connectors.
2. Connect the 2 red wires together using the UL listed
wire connectors.
3. Connect the green (or yellow-green) ground from the
cooktop cable to the green (or yellow-green) ground
wire (in the junction box) using the UL listed wire
connectors.
4. Install junction box cover.3-Wire Cable from Home
Power Supply to 3-Wire Cable from Cooktop - U.S.
Only.
FLUSH INSTALLATION
1. Prepare the countertop for flush installation. Use a router
to cutout the edges of the countertop to specified depth
(.63cm). Ensure all bare edges are sealed.
2. Turn the cooktop upside down on a protective cover &
apply adhesive foam seal around the glass overhang,
5mm from the edge of the glass. Ensure the adhesive
side facing is down to form a continuous seal around the
cooktop.
5mm
3. Trim the excess sealing material using a sharp cutter or
trimmer knife. Take care not to damage the benchtop.
4. Attach the four side clips to the cooktop chassis. Make
sure the clips are oriented correctly, press the center tab
with a flat screwdriver to pass the clip through and secure
against the plate.
Bekijk gratis de handleiding van Elica Volta EIV424BL, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Elica |
| Model | Volta EIV424BL |
| Categorie | Fornuis |
| Taal | Nederlands |
| Grootte | 6655 MB |