Handleiding
Je bekijkt pagina 17 van 36
17
4. Replace the cap back on the regulator.
NG
LP
Changing Injectors
Hob Burners
• Cut off the main gas supply and unplug
the appliance from the mains electrical
supply.
• Remove the burner caps and the
adapters.
• Use a 9/32 " (7 mm) spanner to unscrew
the injectors.
• Replace the injector with the ones from
the gas conversion kit, with the correct
diameters for the type of gas that is
going to be used, according to the gas
injector table.
Adapter
Spanner
Adapter
Cup
Burner
cap
Oven/Grill Injectors (if available)
• The oven and grill injectors are held in
position by a single screw on the tip of the
burner.
• For oven burners, open the drawer
compartment and locate the assembly
screw below the burner. Remove the screw,
move the burner diagonally and the injector
will be revealed on the rear side of the
burner box.
• For grill burners, the screw is already
visible. Remove the screw, pull the grill
burner towards you and the injector will
be visible on the rear surface of the oven
cavity.
Screw
Injector
Oven burner
• Remove the injectors using a 9/32 " (7
mm spanner and replace the injector with
the ones from the spare set. Make sure
you use corresponding diameters suitable
to the type of gas that is going to be used,
according to the information chart (which is
also supplied in the gas conversion kit.
Adjusting the minimum flame position
First of all, make sure that the appliance is
unplugged from the main electrical supply
and that the gas feed is open. The
minimum flame position is adjusted with a
flat screw located on the valve. As shown in
the figures below; for valves with a flame
failure safety device, the screw is located
on the side of the valve spindle and for
valves without a flame failure safety device,
the screw is located inside the valve
spindle. To make adjusting the flame
position easier, we recommend that you
remove the control panel (and the micro
switch if your model has one) during the
alteration. The bypass screw must be
loosened for conversion from LP to natural
gas. For conversion from natural gas to LP,
the bypass screw must be tightened.
Bekijk gratis de handleiding van Element EGR204MCCW, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Element |
| Model | EGR204MCCW |
| Categorie | Fornuis |
| Taal | Nederlands |
| Grootte | 3254 MB |
