Elektron Tonverk handleiding
Handleiding
Je bekijkt pagina 57 van 110
12. AUDIO TRACK PARAMETERS
57
MULT
Multiplier multiplies the SPD parameter by the set factor, either by adjusting the current tempo (BPM
settings) or by applying a fixed tempo of 120 BPM.
FADE
Fade In/Out allows for fading in and out of the LFO modulation. The knob is bipolar. Positive values pro-
duce a fade-out, while negative values produce a fade-in. 0 gives no fade-in/fade-out.
DEST
Destination selects the modulation destination for the LFO. Preview how the LFO modulation will aect
the sound by highlighting a destination. Press [YES] to confirm the selection. Press [NO] to cancel and
revert to previous selection. For more information, please see “APPENDIX C: LFO/MOD ENVELOPE
MODULATION DESTINATIONS” on page 103.
WAVE
Waveform sets the LFO waveform. The Triangle, Sine, Square, Sawtooth, and Random waveforms are
bipolar. The Exponential and Ramp are unipolar.
SPH
Start Phase sets the point within the wave cycle where the LFO will start when it is trigged. 0 makes the
LFO start at the beginning of a complete wave cycle, 64 makes it start at the center. A small square at
the start of the waveform shows that the wave cycle begins at a zero-crossing. If WAV is set to RND then
the SPH parameter changes to SLEW and adds slew to the transitions in the waveform.
MODE
Trig Mode determines how the LFO behaves when a note is triggered.
• FREE is the default free-running mode. It makes the LFO run continuously, never restarting or
stopping even if notes are trigged.
• TRIG makes the LFO restart when a note is trigged.
• HOLD makes the LFO run free in the background, but when a note is trigged, the LFO output level is
latched and held still until the next note is trigged.
• ONE The LFO starts when a note is trigged, then runs to the end of the waveform and then stops.
This makes the LFO function similar to an envelope.
• HALF The LFO starts when a note is trigged, then runs to the middle of the waveform and then stops.
DEP
Depth sets the depth and polarity of the LFO modulation. Both negative and positive modulation depths
are possible. A center setting, 0.00, equals no modulation depth.
12.16 MOD PAGE 5 (FX LFO 2)
The FX LFO 2 page contains the same parameters as FX LFO page 1, but controls the behavior of FX LFO 2.
Bekijk gratis de handleiding van Elektron Tonverk, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Elektron |
| Model | Tonverk |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 15555 MB |