Elektron Tonverk handleiding
Handleiding
Je bekijkt pagina 56 van 110
12. AUDIO TRACK PARAMETERS
56
• ONE The LFO starts when a note is trigged, then runs to the end of the waveform and then stops.
This makes the LFO function similar to an envelope.
• HALF The LFO starts when a note is trigged, then runs to the middle of the waveform and then stops.
DEP
Depth sets the depth and polarity of the LFO modulation. Both negative and positive modulation depths
are possible. A center setting, 0.00, equals no modulation depth.
12.13 MOD PAGE 2 (VOICE LFO 2)
MOD page 2 contains the same parameters as VOICE LFO page 1, but controls VOICE LFO 2.
12.14 MOD PAGE 3 (MOD ENVELOPE)
The Mod Envelope can be used to modulate track parameters. It is similar to the envelopes on the AMP and
FLTR pages but lets you route to a destination of your choice.
ATK
Attack Time sets the length of the attack phase of the amp envelope.
DEC
Decay Time sets the length of the decay phase of the amp envelope.
SUS
Sustain Level sets the sustain level of the amp envelope.
REL
Release Time sets the length of the release phase of the amp envelope.
RSET
Mod Envelope Reset sets the Mod envelope behavior:
ON resets the envelope for each consecutive trig. The envelope’s attack phase is reset to zero.
OFF does not reset the envelopes for each consecutive trig (default). The envelope’s attack phase
continues from where it was left o.
DEST
Destination selects the modulation destination for the Mod Envelope. Preview how the modulation will
aect the sound by highlighting a destination. Press [YES] to confirm the selection. Press [NO] to cancel
and revert to previous selection. For more information, please see “APPENDIX C: LFO/MOD ENVELOPE
MODULATION DESTINATIONS” on page 103.
DEP
Depth sets the depth and polarity of the Mod Envelope modulation. Both negative and positive modula-
tion depth is possible. A center setting, 0.00, equals no modulation depth.
12.15 MOD PAGE 4 (FX LFO 1)
The FX Low-Frequency Oscillators can be used to modulate the parameters of the selected Insert FX 1
and 2. This page controls the behavior of FX LFO 1.
SPD
Speed sets the speed of the LFO. Try settings of 8, 16 or 32 to sync the LFO to straight beats. The knob
is bipolar. The LFO cycle can be played backward by using negative values.
Bekijk gratis de handleiding van Elektron Tonverk, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Elektron |
| Model | Tonverk |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 15555 MB |