Elektron Tonverk handleiding
Handleiding
Je bekijkt pagina 53 van 110
12. AUDIO TRACK PARAMETERS
53
DEL
Envelope delay sets the time before the attack phase of the filter envelope starts. This parameter is part
of the filter envelope that controls the FLTR machine. You can also press and hold [FUNC] and then turn
DATA ENTRY knob A to access this parameter from FLTR page 1 quickly. This parameter only aects the
Multimode filter on FLTR page 1.
SPRD
Frequency Spread osets the filter cuto frequency in the left and right channels.
KEY.T
Keytrack sets how much the filter cuto frequency is aected by what note is playing. The higher the
KEY.T setting, the more the filter opens up at higher notes. This parameter is only available for the Single
Player and Multi Player machines.
BASE
Sets the base frequency of the filter.
WIDTH
Sets the frequency width above the base frequency.
RSET
Envelope Reset sets the filter envelope behavior. This parameter only aects the Multimode filter on
FLTR page 1.
ON resets the envelope for each consecutive trig. The envelope’s attack phase is reset to zero.
OFF does not reset the envelope for each consecutive trig (default). The envelope’s attack phase con-
tinues from where it was left o.
12.7 AMP PAGE
The AMP page controls parameters for the amplitude envelope, panning, and volume.
ATK
Attack Time sets the length of the attack phase of the amp envelope.
HOLD
Hold Time sets the length of the hold phase of the amp envelope. Fixed Hold time values (0–126) specify
the length of the hold phase, and the envelope ignores Note O events such as Trig Length, releasing
a [TRIG] key, or a key on an external controller. Setting HOLD to NOTE means the hold phase will be
determined by Note On and Note O events. This parameter is only available if ENVELOPE MODE in the
TRACK SETUP menu is set to AHD.
If you set HOLD to NOTE and use an external keyboard to trigger the envelope, the sound
will be sustained (if DEC is set to a value less than 127) for as long as you press a key on
the keyboard.
DEC
Decay Time sets the length of the decay phase of the amp envelope. When ENVELOPE MODE is set to
AHD, DECAY works as the REL parameter, defining the time from end of HOLD to 0.
SUS
Sustain Level sets the sustain level of the amp envelope. This parameter is only available if ENVELOPE
MODE in the TRACK SETUP menu is set to ADSR.
Bekijk gratis de handleiding van Elektron Tonverk, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Elektron |
| Model | Tonverk |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 15555 MB |